Mounting the plastic window by your own hands: the features of the process

Do not think that it's hard to install plastic windows with your own hands . This requires only a little patience and accuracy. And outside help may not be needed. Difficulties with installation can arise only if the house is built of wood logs.

First of all, you need to collect all the necessary tools: drill, level, wide chisel and, possibly, metal scissors. And you will need assembly foam, screws, metal plates, with which the window will be attached to the opening, as well as small wedges that will help to set the right level. All work should be carried out in the warm season, otherwise its quality can significantly decrease.

If you have already brought the finished product, then you can do it. Naturally, you should dismantle the plastic window, which you are going to change, and prepare the opening for work. Carefully inspect the slopes: they should not be left with any debris, rotten places, excess plaster. If there are damages, they should be repaired. Also, the opening must be primed with special protective impregnations.

Next, remove the double-glazed windows from the frame and install them in the opening. The wedges and level are used. However, do not tighten the product tightly. This is done only if the window is set correctly. Remember: if you want to achieve optimum thermal insulation, then the depth of the opening must be correct. To do this, measure it and divide the resulting figure by 3.

Next, the installation of a plastic window with your own hands will go quite quickly. It is required to drill holes in the designated places and to hammer in them dowels. All actions must be accompanied by measuring the level of the product. If the frame is installed correctly, you can finally tighten the screws.

Now the installation of a plastic window with its own hands provides for the installation of double-glazed windows. They should be carefully leaned against the frame and secured with glazing beads. The first to put short elements, and then long ones. In order to lock the glazing bead in place, you will need a rubber hammer that does not damage the glass.

After installing the window, it is desirable to remove the protective tape from the surface of the frame. If this is not done in time, then it will be very difficult to remove it. To protect the frame from moisture on its internal surface, you can glue a special tape. Next, the installation of a plastic window with your own hands provides for the splicing of the product. In order that the product is better than the opening, it can be slightly sprayed with water. Do not use too much foam, since it has the property of expanding. However, if the seam between the opening and the frame is wide enough, then the procedure will have to be repeated again.

The last stage, which involves the installation of a plastic window with your own hands, is the installation of a drain. Naturally, after all the performed procedures the product needs to be adjusted. In principle, this completes the installation of the plastic window. Now you can finish the finish of the slopes. Good luck!