Finishing of slopes, choose

A slope is part of the wall that touches the window directly. From it largely depends the design and protection of the entire apartment from external influences. Therefore, finishing the slopes is an important time in the repair. It promotes comfortable stay indoors.

Finishing of slopes should be of high quality. Regardless of whether you live in the old one, or move to a new apartment. If there are gaps in this part of the window, the appearance will be spoiled unambiguously. Nowadays, there are many materials for finishing: various plasters, plasterboard, all kinds of panels. It is possible to pick up any color. A wide range of prices will not burden your family budget.

In principle, everyone can do this. On the Internet there is a lot of material on this topic. But it is better to entrust this serious question to professionals.

Finishing the slopes will give the window a finished look, additional heat and moisture insulation, protects from noise from the street.

Quality finishing always takes a lot of time and effort. Even the master for making a slope from plastic will spend about two hours of time. And if you use plaster or plasterboard for finishing, then it will take about three hours, and more time will be needed for painting the next day (before that the slope should dry completely).

Let's think together about what material it is better to make a slope:

- A slope made of plaster, gypsum board or plastic on thermal insulation practically has the same parameters.

- In all cases, the window and joints are protected and fit tightly.

- The stucco is superior in strength to other materials.

- Compared to the cost of the works, finishing the slopes with plaster will be slightly more expensive with respect to plastics and plasterboard.

- For practicality, the superiority should be given to plastic, it has a smooth surface, is not afraid of water and is easy to clean.

- Making a slope from PVC panels does not require you to finish the wallpaper around the perimeter of the window.

And to fully understand what you want to see at home, you can see examples on the Internet or from friends.

The most common option to date is plastic finishing. As a rule, the population uses plastic windows, so there is a combination of materials. And the garbage after installation is not much at all.

In this version, there is one point that should not be postponed until later. Finishing of slopes should be made as quickly as possible. In the installation of windows around the perimeter, the hole is treated with a mounting foam. If immediately it is not sealed, under the influence of weather conditions (rain, sun), it collapses.

The decoration of the door slopes is carried out in almost the same way. Only materials are required for external surfaces. The same can be said about this type of work, such as the decoration of external slopes.

On the outside, you need a more thorough processing of the joints. Pay special attention to this. Sealants take only frost and waterproof (thus, you exclude the penetration of water and cold).