Textured plaster with own hands

To make repairs by one's own hands is for someone a necessity, for someone a hobby. In any case, the question of decorating the room is always the most pleasant. Here we can translate our color preferences, create a unique image of the interior space, invest in a piece of your mood and character.

In my opinion, the textured plaster of the walls is the technology that makes it possible to make it all a reality. This material is a homogeneous mass containing filler and additives, which, when working on the wall, create various relief motifs. Once the appearance on the plastered surface of scratches and lumps was considered unprofessionalism of the master, and today a diverse combination of strips or grain finish - this is a design approach. Plaster, covered with gilding or mother-of-pearl, is worthy of attention of the most exquisite houses.

The application of textured plaster is possible on various surfaces of concrete, plasterboard, cement, bricks, as well as wood and metal.

Textured plaster with own hands - materials and tools

The plaster mixture is produced in dry or ready-made form. It is available in several types: silicone, acrylic, mineral, silicate. When buying, pay attention to the instruction, where it can be indicated, for which surfaces the mixture is intended. As a filler for textured plasters used a variety of crumbs, fibers, grains of sand, small seashells, etc.

To work will require tools and inventory. Trowel - used to apply and level the plaster mixture. Spatula - better than several and different sizes. Textured rollers, applicators - to create decorative reliefs. For the treatment of the plastered surface, a coarse sponge and an iron grater are used. In addition, you need a foam roller for painting (or a brush), as well as two buckets for plaster and clean water.

Textured plaster with own hands - wall preparation

On the surface intended for plastering, it is necessary to remove the remains of wallpaper, glue, paint, traces of rust or fungi. Before work, read the instructions on the textured plaster, which will prompt the order of surface treatment. Usually, the order of preparation of walls is such: plaster (if necessary), puttying, grinding, priming. Each layer must dry. Do not worry about the unevenness of the wall - textured plaster will help to hide defects. Some brands allow you to apply the mixture simply on a dry surface without primer and putty.

Textured plaster with your own hands - how to do it?

Plastering the wall is better together. It is recommended to process the entire surface at a time. You need to start from the corner, each reception is designed for one - two square meters. While one person applies a plaster layer (approximately 3 mm) with a trowel or spatula, the second one - forms the decor with the help of texture rollers or other devices. The edges of the site should be left uneven so that the joint is not visible.

After fifteen to twenty minutes, when the plaster dries a little, the iron edge compares the sharp edges of the relief a little. After one or two days, the surface is treated with sandpaper to remove pieces of plaster that do not stick well.

Textured plaster with own hands - painting

Dye the surface only after completely drying. A wide range of colorants makes it possible to create a unique design. The wall can be painted and two colors, and also create an effect of antiquity using sandpaper.

In the end, cover the surface with protective wax, which will increase the strength and allow you to wash the wall with detergents.