How to adjust the brakes on a bicycle? Process Features

Every person who loves active life and cycling should know how to adjust the brakes on a bicycle. The thing is that after a long ride, the system can not work very well. So, let's consider when adjustment is needed. First of all, it is made in the event that the brakes are still new and have only been recently installed, or if the system has loosened up and just strikes the wheel without stopping it. If you notice that the bike stops too long, then it must also be inspected carefully.

If you do not know how to adjust the brakes on a bicycle, you must first determine the type of system - vector, disk or tick-borne. Each of them has its own settings. The first two types are used most often, so we will talk about them.

So, let's look at the disk system. Before adjusting the brakes on a bicycle, you should consider their device. On the left side on the bushing next to the spokes is a disk made of steel. To him from both sides are pressed brake pads. Between them and the disk there must be a gleam. Most often, you have to adjust the rotor with a hexagonal wrench. Now, you need to spin the wheel to determine if the pads are rubbing against the disk, if the system is not running. If it is necessary that the brake handle has a smaller stroke, then the hexagon in it must be screwed deeper. Now you need to adjust the wheel and tighten all the bolts. If after checking the bike you notice that the brakes are not fully tuned, adjust the rotor and pads again.

Before adjusting the brakes on the bike, see if everything is in order with the chassis. It may be necessary to replace certain parts, for example, if the pads are broken. If they stand still, but even with a close fit the brake does not work well, try to degrease them. It is desirable that the pads are metal.

Bicycle brakes are very important, because they provide security and allow you to stop. Debugging the system should be done very carefully. For example, rim brakes need to be adjusted so: we turn the bicycle and with force spin the wheel. In doing so, we pay attention to the position of the pads relative to the wheel. The rim should be located strictly in the middle between them. If the wheel is tilted, then it should be leveled, and also move the brake in the desired direction. Pads should be adjusted so that they do not hang over or touch tires. The distance to the rim is adjusted by means of a bolt on the mantle.

The reason for the poor performance of the system may be the unreliable tension of the cables. To do this, unscrew the fasteners, tighten them as much as possible and tighten. If you need a more fine tuning, then you need to spend it during the ride with the help of special controls, which are located on the handles.

Here in brief and all the information on how to set up the brakes on the bike. Be careful and careful. Good luck!