Installation of the block house: technological features

Many have heard the name "block house", but not everyone knows what kind of material it is. Today it is most often used for facing external and internal premises. Installation of the block house does not cause any difficulties in the work, because it has grooves with which it is easily assembled. Often, country houses and baths trim this material.

Its popularity is that it is easy to assemble and has characteristics that are not among its counterparts. The first thing to say, the block house has ventilation slots that are on its inside. Good ventilation allows you to maintain the integrity of the structure for many years. In production there are several types of block house:

1. Vinyl.
2. Wood.
3. Metal.
4. Plastic.

The variety of species allows the consumer to choose a concrete block house for his needs. Mounting of each species is almost the same, except for some trifles. In addition, they do not have the same properties, because different raw materials are used in the manufacture.

Installation of a wooden house block on the front wall

When there is a need to clad the outer walls, the installation of the block house is often performed from wood species, preferably larch or pine. The width of the boards is chosen from 100 mm, but it will be unreasonable to use too wide boards. The optimal option for a pleasant appearance is 120-150 mm. The length of the board is selected as necessary, but most of all the length of the board is 4-6 meters.

Give the opportunity to settle the purchased material in the place where it is planned to install the unit house. The material should get used to this atmosphere. To work with the material during the installation you will need the following:

1. Steam insulation.
2. Moisture protection.
3. Elements of fasteners (bolts and screws).
4. Rims.
5. Thermal insulation.
6. The second crate.

After selecting the necessary tools and materials, you can perform assembly of the house unit. At the initial stage, the walls are covered with sheets of vapor barrier. This helps a special film or parchment. Material insulation is beginning to strengthen On top of the wall, use aluminum tape as a fastener.

Isolation will not be necessary if the installation is carried out on walls that are not exposed to moisture. Further on the vapor barrier is reinforced lath from the dried bar. The thickness of the bar, as a rule, corresponds to the thickness of the insulation material. When the crate is ready, sheets of insulation are placed in the spaces between the bars. Strengthen it with the help of special nails, which have a large round hat.

Next, the insulation is covered with a protective film to prevent moisture from entering. Fasten the film on both sides with adhesive tape, and to the heater are attached with staples. With thermal insulation materials sorted out, now you need to strengthen the second crate, on which the block house itself will be mounted.

The assembly process will not cause difficulties. The design can be assembled from below as well as from above. Make sure that the tongue is always up. It is also necessary to leave gaps from the bottom and top edges of the panel in 50 mm for ventilation. After the end of the assembly, you can primer or varnish the surface to protect.
The most popular in Russia is wooden, rather than a vinyl block house. Most likely, this is due to climatic conditions, and in general the tree, which is qualitatively processed, creates a hormonal atmosphere that is good for health.