How to Cover a Roof with a Ruberoid

How to cover the roof with roofing paper and do the work correctly and efficiently? This question is asked by many townsfolk, who decided, without the help of professionals, to cover the roof of their house, barn or garage. Today they do not use the same material as in the Soviet era, but a new one, with a stone crumb, the laying of which consists of two layers: cushioning and reinforced with stone crumbs. Laying the first is done on a perfectly flat surface using a mastic, a gas burner and a roller. It is necessary to carefully study the question of how to cover the roof with roofing paper, and correctly prepare the substrate, since this affects the quality and life of the coating. Do all the work better in warm and dry time - in spring or summer.

Alignment

Before applying to the surface of the mastic, it must be carefully leveled, dried, rid of pits, mounds and completely cleaned of resin. After all, in the old days the roof was covered with a thick layer of resin, on which the roofing material was stuck. Over time, the resin began to crack and leak. Also, the reason for the flow of the covered surface was the accumulation of condensate in the microcracks of the resin. It also happens if the resin is attached to the material with a stone crumb. Consider how to properly cover the roof with roofing material, so that there is no leakage.

It is necessary to carefully remove the old coating, bring the resin down to the screed. If irregularities are detected, it is advisable to level them with a new screed, which is littered to the horizon at least a centimeter or more, so that water can easily drain off the surface. This can be checked by laser or water level. With the help of threads, beacons are placed, equal to which the screed of cement is poured.

The laying process

The base should be dried, swept away with resin, dust, dirt, and then apply the mastic with a roller or brush. Then wait until it clings, adhering to the time specified on the packaging, which may vary due to the temperature and humidity of the air. After the mastic wears off, it is time to cover the roofing material. It needs two layers: a prosthetic, without pebbles, and the top one, with a stone crumb. There are also combined variants consisting of two layers at once.

How to cover the roof with roofing paper?

Begin the coating from the bottom point, so that the top layers can overlap the lower ones. To make it more convenient to work, the sheets can be cut in advance with the necessary pieces. Apply the first sheet, warm up the gas burner mastic along with the material to a certain temperature, which can be determined by the temperature tape. Then we apply the sheet to the mastic and roll it out with a special roller. Uneven areas of the roof specialists with trampling feet for better adhesion of surfaces.

Stacking in the Rain

Many people are interested in how to cover the roof with roofing paper in rainy weather. The answer is one - to conduct such manipulations in the rain is strictly prohibited. It is better to wait for its termination, and to dry the wet surface with a gas burner. But this is only in rare and desperate situations.

Cost

It is also worth considering how much it costs to cover the roof with a roofing material. On average, one roll of ruberoid costs about 300 rubles. Depending on the area of the surface to be coated, you need to calculate the required number of rolls, add nails or a stapler to this figure. Well, of course, you have to spend money on mastic. In comparison with other roofing materials, roofing felt is considered to be the cheapest and easy to use material. Such a coating turns out to be practical and durable, requiring no additional maintenance.