Correct execution of the course work, recommendations

All students sooner or later get acquainted with writing a course work. This moment in the training activity is very important, as it is one of the stages of preparation of the thesis project. First of all, it is practical and research activity, here the student can not only apply his knowledge, but also include any creative elements, depending on the subject of the project. However, the very design of course work is equally important, although this process is more technical. If the standard requirements that are presented here are not met, the teacher may not even take labor to evaluate.

First, it should be noted that this work consists of several structural elements that are stitched together in a certain sequence. Without fail, the first page is the title page, which is not numbered , but is taken into account when pages are added further.

The scope of the study is determined by the educational institution and the profile department, and may vary slightly. This does not include applications and lists of literature, which was taken for writing. The course design is done on the computer and displayed on sheets of white paper (only on one side). Here you need a font Times New Roman, whose peg is 14 points in the main text and 12 - in footnotes. It is necessary to put transfers automatically, all text and links should be formatted "in width".

Rules of registration of the course recommend introduction, the list of the literature, the conclusion, a new chapter to begin with a new page. Numbering is carried out, starting with the third sheet, after the title and content of the work. The numbers should be located in the lower right corner. Headings are made in bold type (the size is the same as the main text), placed in the center. After them, there should not be a point. It also prohibits any hyphenation, that is, the word at the end of the line should be left completely.

If the work has tables, diagrams or drawings, the design of the course is as follows. If they are small in size, they are left in the text, if more than a page, then they are taken to the application. The diagram and figure are signed from the bottom in the center, the table is on the left from above, through the dash prescribing its number. If it is borrowed from somewhere, a footnote is made, in which a reference to the original is indicated.

Equations and formulas from the text are selected in a separate line. Above and below there must be at least a single blank. The equation that does not fit in one line is transferred on the mathematical sign (+, =, -, etc.), which is repeated twice (at the end of the first and the beginning of the second).

The design of the course provides a correct spelling of the list of sources used. This is a listing of those books, documents, websites that were viewed to write the study. There should be present from 30 titles, which are put in alphabetical order. In addition, the list should be written as follows. Initially, they indicate normative acts or other documents that were taken for work. Then there are textbooks and monographs. After them, there are theses and periodicals. Lastly, foreign literature is indicated, the electronic resources used. In this case, the author (originator), the title of the work, the publishing house, the year of issue are indicated in full.

The material that complements the text is placed in the applications. This can be a large format table, graphic material, any calculations and more. They are necessary only when they supplement the content of the research, have a reference or recommendation character.

Thus, the design of the coursework is no less important than the writing of it. It is quite easy to do this if you follow all the recommendations.