Bath with own hands from foam blocks - inexpensive, reliable and practical

When it comes to the construction of a bathhouse, in the mind for some reason, images of buildings from a powerful wooden beam always pop up. Indeed, from time immemorial our ancestors built baths of wood, but today there are also alternative options. Bath, with its own hands of foam blocks built on the site, is just a practical and economical options.

What is popular about this material? It is relatively inexpensive, in accordance with the characteristics of construction standards, at the same time, the heat-shielding properties of this raw material are more than 2 times higher than that of brick. We can say that this is an artificial building material, it is made from a cement-sand mortar familiar to each and an additional special foaming agent. These additives can be a ready-made foam or be in the form of active substances foaming during the mixing of the solution. If you are faced with the question of how to build a Russian bath with your own hands, consider the fact that the foam in the block structure is distributed unevenly, which contributes to the accumulation of moisture, so it will be advisable to use additional waterproofing materials.

To ensure that the bath, with their own hands of foam blocks built on the site, was practical, you need to choose the right place for construction. The best option is a level ground on a dense ground. The foundation of the bath is laid on the marking of a rectangular trench (50 cm - depth, 30 cm - width). The frame is prepared from a 12 mm armature , for its horizontal connection a wire or thinner reinforcement is used. If the trench is a level and dense ground, the concrete for the foundation can be poured without formwork, it is installed in this case only for the ground part. In the end, the total height of the foundation should be about 70 cm. After a while, when the concrete will gain strength, you can start laying the flushing sewer. The whole surface is covered with a layer of rubble, directly over which a layer of expanded clay can be laid as a thermal insulation. Sometimes for a better moisture protection in concrete add a special additive.

Then our sauna begins to be drawn directly. With your hands from the foam blocks you can build different designs. Specifically for the bath, the optimal material parameters will be as follows: M25 foam blocks, density D700, 10x30x60 cm. Stacking is carried out on the rib. Seams between the blocks make it as thin as possible to prevent heat loss during operation. The first block row is placed on the cement slurry (it is checked by level, adjustments are made with a rubber mallet). The second one - with a half-block shift, etc.

A few days after the construction of the walls, you can begin laying the rafters and horizontal timber under the roof. There are different options for erecting the roof, perhaps the most simple - a gable roof with a ridge in the middle. The rafters rest against tightening and must necessarily dock with each other on the ridge with a thorn. Rafters for strength with metal clips are associated with tightening. The step between them is determined depending on the length of the roof (100 - 130 cm). It is also important to choose the right material for the roof. For example, if it is wood, then it must be only first-class and without knots. After the completion of the preparatory work on the crate is placed the roof.

As you can see, the bath with its own hands made of foam blocks built on the site - this is quite real. And still relatively inexpensive, reliable and practical. Moreover, in visual and practical characteristics, this option can be no worse than the best Turkish bath. It's always done with quality for a long time. Good luck in your endeavors!