How to put the tiles in the bathrooms

If we talk about how to put the tile, then for starters it is important to determine the appropriate materials. After that you can start working. The whole process begins with the preparation of the walls. The appearance of the resulting coating depends entirely on how well you will do everything at this stage. How to lay the tile: prepare the walls

To begin with, remove the coating from the surface before repair. The old material seems to be quite reliable, but it is necessary to get rid of it. The walls must be thoroughly cleaned of dust, and then through a level check them for verticality. At not absolutely equal walls them it is required plastered. If we talk about how to put a tile in the bathroom on the wall, it is important to remember the primer. The primer is designed to fill the pores on the wall surface, which allows for better adhesion of the adhesive layer. The composition should be moisture resistant. When all this is done, you can proceed directly to the stowage.

How to lay a tile: basic work

Technology in this case is not particularly difficult. The main points in the work are a constant control of the vertical and horizontal lines, as well as accuracy. Tiles are easier to lay in small areas. When planning a beautiful design, you must draw on the wall small sectors, which in height are equal to four tiles. On such a site, you can easily apply adhesive. You will always need a level to check the evenness of the rows in the process of laying the tiles. It should immediately eliminate the identified deviations from the horizontal or vertical level. In the process of laying between tiles it is necessary to lay out special crosses, which allow obtaining seams of the same size.

Talking about how to put the tile, it is worth noting that it is inappropriate to use cement mortar for these purposes, especially if you are not experienced enough in this case. It is best to use a special glutinous mixture, which can be purchased at a construction store. Usually it is applied to a wall, not to a tile. This is done using a special notched trowel. The surface should be smoothed evenly, while ensuring that the consistency of the glue is normal. On vertical surfaces it is necessary to use compositions that freeze as quickly as possible.

If we talk about how to put the tile on the floor with our own hands, then we can say that in solving this problem there should be no difficulties, since it is important to observe similar conditions. When laying each new row, the tile must be pressed against the surface, however, do not exert maximum effort, as it is possible to squeeze out the glue. The outermost composition must be removed with a sponge until it is dry, and the hardened compound is removed with a wooden or plastic spatula. After laying, you should wait until the glue dries, and then you can begin to grout the seams. Usually, after finishing work, you can immediately wash the tile.