How are the basins assembled? With your own hands, this is done quite simply

During the summer heat, owners of any land can indulge themselves in swimming in the pool. At the same time, you do not need to buy an expensive finished product and invite specialists. You can build a skeleton pool with your own hands. Such pools can be installed anywhere and anytime. The main thing is that the playground is firm and perfectly level. Frame pool models are almost the most popular along with inflatable. Often, in addition to the instructions and the construction, the kit includes even the necessary equipment for installation.

Site Preparation

Making the basin skeleton with your own hands, you must first carefully level the surface. Raise the base of the ground is dangerous. Over time, the embankment is washed away, and the pool may be damaged. It is most reliable to remove the fertile layer together with vegetation and roots and replace it with five centimeters of sifted sand. The geotextile lining will protect the basin from various damages.

Assembling the pool

Before installing the basin skeleton with your own hands, you will need to lay geotextiles on the already prepared area. Then we open the box and lay the basin bowl over the deck. The hole intended for draining must be turned towards the water outlet. After the material is warmed by the sun, you need to insert the posts and beams into the corresponding holes. It is important to act consistently. Therefore, all the installation should be done exactly according to the instructions that are attached to the pool. It is worth to know that to assemble the basin skeleton with your own hands, namely their individual modules, you can without special tools.

Final preparation of the basin

Swimming pools for the dacha are to be installed strictly horizontally with respect to the ground surface. Before filling the pool with water, it is important to make sure that the structure is positioned correctly, the drain plug is tightly closed and its lid tightly twisted. If there are no problems, you can spread the folds and fill the container. After filling, you need to adjust the acidity of the water and disinfect it.

Certain moments

Assembling the basin skeleton with your own hands, do not forget about some specific nuances. First, you need to mount the frame and paste geotextiles to it, only then the bowl is placed inside the contour. After hanging the canvas on the walls do not need to fix it over the entire area. In order to spread the liner neatly, you need to partially fill the bowl with water. For better fit of the material to the frame, it is necessary to seal the cutout under the screamer with adhesive tape and draw air through the hole. When the water rises by 15 cm, you can install a skimmer and a return nozzle. The frame pool is ready!

Conclusion

As you can see, there is nothing terrible and complicated in the assembly of this device. Is it worth spending money on hiring special brigades? But it's up to the owner of the frame pool to decide everything. However, if you decide to cope with the task yourself, then this review, no doubt, will be able to help you. Good luck in creating a place for swimming!