Car safety locks

Car safety locks are a very important detail of any vehicle. To purchase good and quality parts is spent more than one hour, and that's the purchase of this thing, it's worth spending the right amount of time.

Some are dismissive of the choice of parts such as car fuses. Like, that complicated - it's just a plastic part, inside of which is a fusible element. You can buy any. But this approach is careless. If you purchase a low-quality product, you can get two troubles in return.

If the car fuses burn out inappropriately, then you can leave your car without rain wipers functioning in the rain. It's insulting and bad, but it's not the worst. Here is the second more difficult. The fuse may not work during a short circuit. Here are the consequences of this case are quite dangerous, as the result can burn the wiring (at least) or the car. An indirect cause of problems arising in the car may be a short circuit. However, the main problem usually lies in such details as auto-fuses. Sometimes, due to rising voltage, the fuse can not stand, and the plastic case begins to melt. And because of such trifles, the whole car might well burn! To avoid this situation, it is worth considering some rules that should be taken into account when choosing such an important detail as car fuses.

To get a better set, not one by one. And it is necessary to pay attention to the information that is given about the manufacturer. It is indicated on the package. If it is not available, then it is better not to purchase this kit. If the plastic, from which the car fuses are made, is transparent, then the owner of the machine will be able to detect the malfunction of this part visually if the fuse element burns out. However, there are products that are made of opaque plastic, but function remarkably, meeting all standards and tolerances. Now you should pay attention to the technical requirements that are imposed on these details.

Serviceable fuses for the car must work for a hundred hours at a current that exceeds by 10 percent the nominal (no reflow of the hull). And they should not burn out! On the pins, a voltage drop of up to 150 mV is permitted (for fuses 7.5 and 3.5, and also for 15 and 10 A) and up to 115 mV (30 A), 125 mV (25 A), 130 mV (20 A). This product should be triggered in 0.15-5 seconds (at a current that is twice the rated current).

So, what to do if the fuse is still faulty? First it is necessary to take it out of the socket, and then insert it into the vacant place a new one (only necessarily the same number must be on it). In order to remove this part, you need to use a special plastic clothespin, which usually comes complete with the product itself. However, if you take into account all of the above recommendations, the fuse will last a long time.