Well rings in construction

Well rings are made of reinforced concrete. The process of their production is that the crate of the reinforcement is covered with concrete. This is how the rings are made, from which the neck is made for sewage, gas, water, drainage and drainage wells.

Construction of wells

Work on the installation of the well must be performed by professionals. During construction on the site, hydrogeological surveys are carried out. In order to find out at what depth the water lies, it is necessary to study hydrogeological maps or consult specialists. For the construction of a well, well rings, a lid and a bottom are required.

Kinds

Unified well rings - high quality concrete products. These rings can not be corroded and are resistant to negative factors. With their help, they establish trunk communications. Such wells are:

• Sewage;
• Water supply and gas;
• Drainage.

Advantages of reinforced concrete wells :

• Low cost (compared to drilling wells);
• Durability and reliability of products;
• Universality;
• Simplicity in operation;
• Hygienic products (do not skip pollution).

Features

Concrete products of this designation are presented with rather high requirements. Wells are important elements in the communication system. They are different in size, diameter and mass. Depending on the purpose, the rings are indicated by the letters: KC, KS, KCD, K or KCP.

Installation

When planning a well, you need to make sure that this place is located The groundwater. There are rules that all professionals who install wells know. Plum pits, saunas, livestock places - all this should not be located closer than 25 meters from the well. Do not dig wells on the banks and slopes of rivers. After deciding on the place, they begin to extract the soil. It is necessary to consider the following: if the soil is soft, remove it, starting from the middle, and with hard ground work is carried out, starting from the edges of the well. The next step is to install well rings. Such work is performed by special cranes, which they lower into niches. Then the rings are fastened together by steel staples and concrete solution (special astringent substance). Professionals know that digging wells must be done before the rainy season starts.

Technology of production of rings

The production of rings is organized in such a way that as a result the surface of them is ideal. When making RCW rings are well, it is necessary to use the following equipment: concrete mixer, vibroform and lifting device. The concrete mix is loaded and within three minutes a vibrocompression is produced. Ready-made concrete for rings includes such components: cement, plasticizer and crushed stone with sand.

Conclusion

In the construction of any facility, water, sewage and gas pipelines are installed. Carrying out these works, always use concrete rings. The use of such products is economically feasible.