How to wash whitewash from the ceiling quickly and efficiently

About ten years ago, the main means for decorating the ceiling was the usual whitewash, which was applied with a special brush or with a sprayer. Modern technology allows you to create a new design of ceilings, but this requires removing the old whitewash as best as possible. Bonding of the ceiling with polystyrene tiles, surface plastering, painting with water-dispersion paints - all these types of finishing require preparation of the substrate and removal of lime as high as possible.

Methods of removing the old lime coating are known a lot. The most common of these is washing off whitewash with water. The procedure will require a lot of time and physical effort, but the result is worth it if you plan to make spectacular and quality repairs. First of all, it takes a lot of time to apply water to the ceiling with the help of a spray gun and further remove the wet whitewash with a metal spatula. For maximum effect, work should be done sectionally and avoid drying out the wetted areas of the surface.

Tools for removing old coatings

If you do not know how to wash whitewash from the ceiling, remember that before you start working, you need to prepare all the required tools. This will facilitate the work and will once again not look for a spatula or sponge in a lime-freshened apartment.

You will need the following tools:

- spatula of medium width to remove the composition;

- sprayer with water to wet the ceiling and soften the whitewash layer;

- a respirator to prevent small particles of suspended matter from entering the respiratory system;

- To protect the head, hands and other parts of the body should wear a handkerchief, gloves and work clothes;

- a film or paper will help protect furniture and the floor from getting contaminated particles, so that after work not to puzzle over the question: "How to wash it all off?" (To decide the question of how to wash whitewash from the ceiling is much easier than to wash it off the floor and furniture);

- and do not forget about the stepladder, since without it you are unlikely to get to the ceiling, and the use in this case of the table and chairs is undesirable from the point of view of safety.

This method is most accessible for those who do not have the appropriate skills in the matter of how to wash whitewash from the ceiling. The main disadvantage of the technology is the formation of a large amount of dirt in the room, which can be difficult to remove.

Other methods of removing whitewash

If the above described method does not suit you, you can try other methods:

1. The method of removal using a paste is a process of wetting the ceiling with a liquid solution intended for gluing the wallpaper, and further scraping with a spatula. With this method, whitewash does not turn lime into fine particles, and the slurry thereby does not pollute the space.
2. Removal of the coating with a soap solution. To make a solution, you need 3 tablespoons of ground soap, 10 liters of water and a few spoons of salt. The resulting composition is necessary for wetting a large size sponge and washing the whitewash without the aid of a metal spatula.
3. If you do not know how to wash whitewash from the ceiling, and any of the ways associated with the formation of a large amount of dust in the room, is unacceptable for you, then use a deep penetration primer. Just apply the composition to the ceiling and continue to finish over the old lime coating.

The prepared base can be subjected to any further finishing: painting with a roller, wallpapering with wallpaper or tiles, installation of stretch ceilings. To wash off or not to wash off whitewash is up to you, but if you treat lightly to such a serious matter, you can get serious problems. So, for example, whitewashing can collapse in a thick layer and damage the new ceiling decor . The decoration of the ceilings in the apartment is a complicated process, if you doubt your abilities, invite specialists.