How to put a tile in the bathroom

For many years now ceramic tiles are considered to be an invariable attribute of bathrooms, kitchens, toilets. Even the appearance of new finishing materials could not push the tiles into the background, it is still considered one of the most practical ways of finishing walls and floors in rooms with high humidity.

Various in form, size and decor of the collection of ceramic tiles allow you to realize the most daring design solutions, create an interior unique in its beauty and originality. Moreover, the ceramic tiles took a bold step and confidently went beyond the kitchens, toilets and showers. Today it can be found on the floors of hallways, balconies and even living rooms, which indicates the extraordinary popularity of this beautiful material. However, in this article I would like to talk about how to put the tile in the bathroom.

On how well it will be put, the future appearance of the room completely depends. Of great importance, of course, are the professional skills of the home master, but also the preliminary preparation of walls and floors can not be discarded from accounts either. In addition, before you put the tile in the bathroom, you need to replace the water pipes, electrical wiring, sewerage and other necessary communications.

If oil paints remain on the walls , it must be carefully removed. All protuberances on the surface should be knocked down, and the walls themselves should be leveled with a layer of plaster, preferably on a cement base. Particular attention should be paid to the angled corners. Ceramic tiles - this is not a wallpaper, it can not be pulled. Therefore, all the irregularities of the corners should be carefully adjusted, otherwise ugly gaps will form in places suffering from special curvature. Which, naturally, will reduce all efforts to "no". All the above recommendations apply to sex. The substrate for the tile should be smooth, dry and clean. For better adhesion, the prepared walls and floor can be primed with a special compound that can be purchased at any construction store.

Before you put the tiles in the bathroom on the walls, you must first polish the floor. If, for some reason, the first provides for the decoration of the walls, then between the lower row of wall tiles and the floor, you need to leave a small gap.

The installation of floor tiles is done in two ways: from the center to the corners (symmetrical masonry) or from the most prominent angle to the farthest corner (masonry is asymmetric). In a suitable container, the adhesive composition is kneaded according to the instructions, then the finished mortar is applied to the floor with a special notched trowel. A solution is not necessary to apply a lot, enough of its quantity, enough to lay one or two tiles. Each tile is pushed into the glue by turning movements, the excess of the solution is removed with a spatula. To ensure that the gap between the tiles turned out to be accurate, it is adjusted with special plastic crosses.

How to put a tile in the bathroom on the walls? The process is similar to laying floor tiles. Facing begins with the bottom row and the most prominent corner, gradually moving up and toward the far corner. Quite often there is a need for trimming tiles. Some old masters give very practical advice on this matter. Before putting the tiles in the bathroom, several pieces intended for trimming, it is necessary to soak in water for a couple of hours. This tile will then be much easier to cut.

The quality of stacked rows must be constantly monitored by the construction level. While the glue does not begin to dry up, some styling defects can still be fixed. In the gaps between the wall tiles, plastic crosses are also inserted, so that the seams are the same and perfectly even.

Tiled glue dries for two days. After the adhesive composition has completely dried, the tile must be cleaned of the remnants of the mortar and the tile joints should be sealed with a special grout, using a rubber spatula as a tool. Today, grouts of almost all colors are sold, so you will not be able to find the right shade of special labor.