How to install mosquito nets yourself

Mosquito nets are becoming increasingly popular, and this is fully justified. Often when installing plastic windows , customers have a question: "How to install mosquito nets?" In general, it's quite simple, if you mount it together with a window, but on previously installed ones - there are some difficulties.

How to determine the parameters of a mosquito net? To do this, you need to measure the size of the sash where you intend to install the mesh. From the results, subtract 26 mm from the width and height. This will be the preliminary calculation of the grid. Then open the window and check its entry into the wall, the frame should be no less free, even preferably more 20 mm on each side. Be sure to attach the mesh to the opening, it should be found on the frame on each side of 15 millimeters. If so, you can safely acquire it.

Materials

How to install mosquito nets and what materials you will need - we will consider further. Basic tools:

• Upper fastening (longer) - 2 pieces;

• Fastening bottom - 2 pieces;

• 8 small screws (use usually shiny silvery screws 14 mm) and a screwdriver.

Now let's move on to the process itself.

How to install mosquito nets in an apartment?

Initially, try on the canvas so that there are no cracks around the perimeter. Attach one fastener from below about 3-5 cm from the corner. Next, align the grid so that it is level with the entire opening. Then attach the second lower fastener. Install the grid in the lower fasteners and mark the top of the line. To finish the installation, attach the upper fasteners. Note that they are not tucked close to the grid itself, but above about a centimeter so that you can later remove it. It will be quite sufficient to superimpose them on it at 3-4 mm. Install the mesh in the fasteners - first wind the top part, then lean it against the frame and lower it down.

How to install mosquito nets in homes?

First, you need to remove the platbands before installing, marking and tracing, so that the edges fall on the plastic. Check if the clypeon is in place. If not - you can simply lower it slightly and fix it with the usual (3x16) screws. Try on the grid, having driven it approximately on half of the top fixture, put a label. In this case, the clypeus can not be removed, just slightly bend. Align and install the lower fasteners. Then enter the grid up, press it against the frame and release it.

When it is not possible to install mosquito nets

• Most of the old wooden windows have a protruding element at the bottom of the sash (a drip tray is for draining water). If you set the grid on it - when closing, the capnick squeezes it out into the street.
• Single-folded recessed window with external walls. It is not possible to install a grid on z-fasteners. With the rest there are no problems.
• Windows with oblique or rounded outer quarters.
• The frame is closed with a window quarter. It is possible to install only the rod mesh, as it is installed inside the opening.

Mosquito nets: price

• Standard - from 1000 rubles.
• Stuck - from 1300 rubles.
• Sliding on the rails - from 1600 rubles.
• Mesh plisse single-leaf - from 15 000 rubles.

I hope we answered the main question: "How to install mosquito nets?". Use on health.