How to change engine oil in an hour?

If you are not strong in auto mechanics and do not know how to replace engine oil without resorting to car workshops, then this article is for you. The process itself is not anything complicated. In order to learn how to change the oil in the engine, it is only necessary to follow a certain sequence.

The first stage is preparation for work. After you have bought engine oil, you need to find some canister to drain the waste fluid. Usually its volume depends on the type of engine (2.5-5 liters). We will also need a new oil filter, a wrench and a few unnecessary rags. If you can not get close to the oil filter or put a container under the tray, then you have to change the oil on the inspection pit or overpass.

In order to heat the oil in the crankcase, allow the engine to idle for a few minutes at idling speed, and then muffle the engine. After that, any auto mechanic who knows how to replace the oil in the engine will find a drain plug. The latter is at the bottom of the pallet. Armed with a rag, unscrew the drain plug (the main thing - do not burn yourself) and place under it a pre-prepared container.

After the oil stops draining, it is necessary to unscrew and remove the old oil filter, draining the remaining oil from it. If the screws can not be screwed with a screwdriver, there is one proven method. You can pierce the filter with the tip of a screwdriver, and then use it as a lever. The rim of the new filter must be lubricated with oil and replace it with the old one. When replacing the filter, the old oil will completely drain out of the engine components, and then screw the plug back. How to replace the oil in the engine? Unscrew the oil filler cap and start pouring a new one. The upper level is approximately, not adding half a liter. Tighten the lid and start the engine again to work for 30 seconds on idle, but do not gas!

After the oil has passed through the motorways, check the area near the drain plug for leaks. Stop the engine and leave the car for a few minutes to allow the oil to "settle", and then top it up to the level indicated on the dipstick. It remains to travel a few minutes and make a check-up of the oil level, with insufficient quantity - top up.

Now you have learned how to correctly replace the oil in the engine. After the end of the procedure, do not be lazy and write down the mileage of the car and the date of the procedure. You can also tear off the label from the canister and stick it on the back of the hood to know next time what kind of oil was in the engine. In order to clean the engine components and mechanisms from wear products and slags, use the washing oil.

How to replace the oil in the engine with flushing? Everything is very simple. After you salt the old one, pour in the rinsing water and start the car again for a couple of minutes, and then drain the rinse. Important: the new filter is not installed before the washing process. Wash oil is not recommended when the engine is completely overgrown. It is better to take a fresh motor, although it is more expensive, but the motor will be cleared better.