Filter for washing machine: cleaning and elimination of small faults

Automatic washing machines can greatly facilitate the life of the housewife. To date, such devices are available in almost every home. When they are manufactured, the most modern technologies are usually used. Therefore, such household appliances are sufficiently reliable. However, sometimes machines do break down, they require replacement or washing of any parts. For example, it could be a filter for a washing machine that needs periodic cleaning.

When it clogs, the automation can start to work intermittently or stop altogether. In this case, the filter must be cleaned. It is not too difficult to do this. The first thing to do is to open the falshpanel in the front of the machine. Behind it is a decorative filter cover, which must be unscrewed. Then a filter for the washing machine is pulled out from the opening and cleaned. After cleaning all the actions are done in the reverse order - insert the filter, tighten the lid and put in place the panel.

In addition to cleaning the filter, it is sometimes necessary to clean the washing machine itself. To get rid of the scale use antinakipin (acid-containing agent) - a specially developed for these purposes, the drug. Do not confuse it with the usual water softener. Cleaning of the washing machine is as follows. The device is filled with water, which adds antinakipin. Then, laundry is done without laundry.

Sometimes the washing machine can stop due to the failure of the mains filter. The main task of this design element is to protect the electronics of the machine from sudden surges in the network. If this part fails, the machine will not work. However, you can fix this problem in two counts. It is enough to remove the mains filter for the washing machine in general. The automation will perfectly cope with the task without it. This, by the way, is the only detail in the washing machine, which can not be changed to a new one and not repaired.

But, of course, all manipulations must be carried out correctly, in compliance with the relevant safety rules. Consider this process using the example of a washing machine brand Candy. The filter is usually located in the back of the case, at the top. It represents a cylindrical piece of gray or beige color. In order to get access to it, you need to remove the top cover of the washing unit by unscrewing a few screws. The filter for the washing machine is carefully removed and pulled out of the housing.

Now you will need to get the wires connecting it with the machine. The yellow wire is grounded, it is left as it is, the rest is to be connected in pairs, pre-pressing the ends with pliers. Blue is twisted with green, light brown with dark brown. The joints are wrapped with electrical tape. Then the wires are fixed with a rope inside the case. Everything, the filter for the washing machine is removed. It remains only to check the resistance. To do this, connect the tester to the fork of the machine and start it in any mode by pressing the corresponding button. The device should show a resistance of at least 2 ohms.