Electricity from the air with your own hands. Is it possible to extract electricity from the air

In our time, a specter of energy crisis arose. Mankind is looking for different answers to this challenge, offering a solution in the form of atomic energy or alternative energy sources. But what are they? Can an "ordinary" ordinary person be able to enjoy the fruits of technological progress by collecting what will allow them to operate electricity sources with their own hands? Yes, and the implementation will be shown in the article on the example of wind energy.

Opportunities for alternative energy

But initially we will talk about alternative energy in general. Its feature is that energy sources are used that will not run out in the near future. The disadvantage, which is hampered by its widespread introduction, is the binding to certain parameters of the environment and a long payback period.

But the above opportunities are not what is the main goal of the article. Here we will talk about such an unusual method of obtaining energy that most people do not know about him. So, how to get electricity from the air with your own hands?

Getting energy from the air

And what about wind energy? First, always remember about it. It requires fast enough air flow, windmills, which will rotate and turn the mechanical energy of the wind into electricity. The best option is if the wind speed is more than 5 m / s.
The mechanism of transformation is that the wind rotates the blades of the windmill, which are connected to the current generator. Since mechanical energy is supplied to it , the generator turns it into electrical energy.

But the most exotic way of mining is electricity from the air with your own hands. Not by air, but from it. How is this possible? Probably, many of you have heard about the fact that electrical devices create electric fields, so why not draw energy from these fields?

What is needed to create a simple power generation station?

How do you get electricity from the air? The minimum required to extract electricity from the air is ground and a metal antenna. Between these conductors with different polarity, an electrical potential is established, which accumulates over a long period of time. Given the volatility of the magnitude, it is almost impossible to calculate its strength. A similar station operates like lightning: the current discharge occurs after a certain time, when the maximum potential is reached. In this way, you can get quite a lot of electricity to support the operation of the electrical installation.

Schematic representation

You are probably interested not only in electricity from the air. The scheme how to make it is the most important. Well, I propose to look at how she looks. In general, nothing complicated, and in the picture everything is signed. Only it is necessary to say: do not try to call a telephone receiver with headphones. If they called it that, electricity by their own hands, the scheme and its implementation are not for you, too little experience.

Consider the pros and cons of the design.

First about the pros:

1. Simplicity of construction, thanks to which practical repetition at home is not a difficult matter.
2. Availability of materials required for the project.

Now about the shortcomings:

1. It should be taken into account that, despite its simplicity, the circuit is extremely dangerous because it is impossible to calculate the approximate number of amperes and the current pulse strength.
2. The formation of an open ground loop during operation, which can cause lightning strikes up to 2,000 volts. This was the main reason why the installation was found to be unsafe for life and, accordingly, did not put it into production.

Therefore, electricity obtained with a solar panel or wind generator, and is more secure. But you can buy a mechanism of similar action - it's Chizhevsky's chandelier (one of the most amazing Soviet developments). Although it does not allow receiving electricity from the air with our own hands, it is a very interesting design.

Alternative Mark

The device is also known as an electricity generator from the air TPU, developed by Stephen Mark. It allows you to receive different amounts of electricity to feed different targets, and this is done without the need for recharge from the external environment. But due to some features it still does not work. Such a problem does not hurt, however, to tell you about it.

The principle of operation is simple: a resonance of magnetic vortices and currents is created in the ring, which contributes to the appearance of current impacts in metal taps. To assemble such a toroidal generator, which allows you to get electricity from the air with your own hands, you need:

1. The base, which can be a piece of plywood, like a ring, a polyurethane or a piece of rubber; 2 collector coils (external and internal) and a control coil. As the base, the ring with the outer diameter of 230 millimeters and the inner diameter of 180 is best suited.
2. Wind the coil inside the collector. The winding should be a three-turn and be made a strand made of copper. Theoretically, to power a light bulb, you should have one turn as in the photos. If it did not work out, do one more thing.
3. Control coils need 4 pieces. Each of them should be placed at a right angle, so as not to interfere with the magnetic field. The winding should be flat, and the gap between the turns should not exceed 15 millimeters. Less is also undesirable.
4. To wind the control coils, use a single-wire cable. It is necessary to make at least 21 turns.
5. For the last coil use a copper wire with insulation, which should be wound around the entire area. The basic construction is completed.

Connect the pins, having previously installed a capacitor of ten microfarads between the ground and the back ground. To power the circuit, use multivibrators and transistors. Select them will have to be experienced due to the fact that we need different characteristics for different designs.

Alternative Kapanadze

I would also like to offer you a diagram that will probably describe Kapanadze's invention. It is based on Tesla's coil, which can accumulate electricity. Whether this is so - you can check personally.