Athermal film

Virtually any athermal film can create protection. For the eyes, it will remain invisible. It will perfectly cover the interior of the car from sun rays and overheating. Especially in this need cars, the interior of which is covered with leather. After all, under the influence of the sun, this material dries up and begins to crack, increasing the hardness of the coating. Plastic parts also become less elastic, coarser. The textile lining fades, the brightness and color saturation is lost. The thermal film helps to protect the car interior from ultraviolet rays and will preserve the original form of materials for a long time. Will protect details of furnish.

The machines treated with a protective film of glass will not allow the car to overheat, so the owner will feel comfortable enough. This will reduce the load on the air conditioner, reduce the financial costs of the owner (fuel consumption is reduced).

Recently, the atmal film LLumar (American production) is often used. Has a light transmission up to 80%. For its production the latest technologies and high-quality material are used.

The film is produced with the use of ultraviolet absorbers, this will protect the passengers and the interior of the machine (it detains about 99% of the sun's rays). It has several layers of coating, one of which has increased heat-reflecting qualities. All layers join a special adhesive composition.

The athermal film has a dielectric coating in its composition, it does not interfere with the signal of radio waves and mobile communication. This allows you to freely use the Internet and a mobile phone.

In the production of glue systems HPR, CDF and PS are used, they provide the necessary adhesion of the product.

This type of protection has two series. ATR - has a neutral carbon shade, this can significantly reduce the burden on the eyes. LA - a series that has a bluish tinge. This is worse for human eyesight, because when the deviation from the neutral color is distorted, the eyes get tired much faster.

When tinting a perfectly flat surface, the ATR film has a smaller ripple than the LA series. This is clearly seen when looking at an angle of 15-45 degrees.

In the case of an accident, toning will protect passengers and the driver from broken glass shards. Upon impact, they will remain on the film, which will not allow injuring a person.

Athermal film has many colors and shades. Therefore, color tinting of the right parts of the car is possible. You can choose any color. With the help of such a film, your machine will turn into a unique vehicle.

Do not forget that the light transmission of glass should be at least 70%. The films fully meet all the requirements. However, we must take into account that the glass itself does not have a capacity of 100%. Even a new factory allows about 90% of the light.

Therefore, in order to comply with the technical installation rules, you should choose a film with a light transmission of at least 80%. Now you can start work. Just do not forget to comply with all of the above rules.