Woodworking Technology

The woodworking technology is capable of increasing productivity, provided that a gluing agent such as urea-formaldehyde resin is used. Undoubtedly, the optimization of the production process depends on the human factor, therefore, it is necessary to increase the supervision of workers . The woodworking industry is experiencing the highest point of technological recovery: the technology is optimized for the needs of enterprises, is dynamic, fully consistent with the commercial rules of the modern era. Normally, in the race for reducing the cost of the product, you have to use unusual methods that were previously considered unattainable. The technology of wood processing can multiply its effectiveness in times when some optimization measures are introduced, for example: increasing the control over the rate of consumption of raw materials, improving drying and movement of products on the territory of the enterprise, grinding, pressing and other stages of technological development. Yes, the technology for the production of chipboards depends entirely on non-production factors, therefore, the improvement of technological production, first of all, must concern personnel changes, the supervision of the fulfillment of direct duties by employees must certainly be improved.
The state-of-the-art wood processing technology is based on precise calculation of sawing, maximum efficiency regarding economical use of wood. Manufacturers of DCS for today use milling machines with cnc, special software, which guarantees the maximum accuracy of cutting. In recent years, such technology has advanced significantly. I believe that the production chip has recently been pressed with greater strength and a bonding agent capable of withstanding long-term operation even in the case of constant moisture. Production, in which the main raw material is the technological chips, has come close to properties of the production process, the initial product of which is an array of wood. I am pleased to realize that, because of the use of a binder composition, "urea-formaldehyde resin", a laminated board of dsp can withstand the effects, at times overlapping the GOST-approved numerical values.
As I have already said, the optimization of the production process of the woodworking industry and the production of chipboards is based on an impeccable calculation. Calculation of the supplies must be performed in such programs as for example: AutoCAD, Microsoft Visio, KOMPAS-3D. These software products will help to cut a small diameter forest. Although, as practice proves, all this is enough to process more than 70% of wood.