We make watches by our own hands

In order to independently make the clock with your own hands, you need any vinyl plate with the necessary dimensions. Remove the label. It's best to take a plate with a mid-white color, since the red one will be quite difficult to interrupt with white color.

To make the watch your arms, you need to try to buy a mechanism in special shops or watchmakers. As part of the standard set, there should be a clockwork mechanism, arrows showing minutes, seconds, hours, washer, central nut.

Plank the plate with white soil from the can. It is more correct to apply primer of universal type or with the content of alkyds. In addition, using acrylic paint of white color and a sponge, you can paint the plate, but you should keep in mind that during the application of soil with aerosol, the surface will be more suitable for work. At the end of this, dry the finished work.

Creating a background and clock with your own hands, mix the paint and apply it to the surface of the plate. Dry it.

Further. To make a clock with your own hands, based on a decoupage map, you need to cut out the motif. To do this, plaster the surface of the plate with PVA glue, wet the card, put it on the glue, do not forget to glue it with glue on top, make sure that each bubble is removed from the decoupage map, and dry the surface with a hair dryer.

To make an electronic clock with your own hands, you can buy cards of firms "Richelieu", "Decomania", and cards with a basis of rice paper. It is necessary to place a sheet of decalcomania in a container filled with water, in order to transfer the napkin to the surface and leave it for about five minutes. Next, get a sheet, allow to drain water, then put a sheet on the base and translate the drawing. After the sheet is transferred, use a spatula to get rid of air bubbles. Dry the pattern, then cover it with varnish.

Rice paper must be varnished at least three times. After that draw a contour, paste the figures from the plastic on the clock with your own hands.

When a hole is stuck in the decoupage map, you can make a hole by inserting the scissors and turning several times to increase the diameter of the hole.

Next, to make the clock with your own hands, you need to insert the clockwork mechanism, insert a flat washer and tighten it with a nut. In the case where the mechanism is provided with a loop, it is required to fix it on the back of the plate. When the loop mechanism is not provided for, you can do it yourself, for this, glue two loops on the glue "Moment", and tie a wire or rope between them. You can use a sponge to make the arrows better visible, paint them. Dress each arrow. Since each arrow has a different hole, the order will not be confused.

Insert the battery.

Satisfies the moment that the process of making such a watch takes about four hours. You can apply primed canvas, unnecessary disks, wooden palette as a basis for future hours. The clock mechanism can be purchased, or can be adopted from hours that were in use. On the ways to decorate the scenery and not to say, there are many.