Project: guest house with a bath and a swimming pool (photo)

Before you start building a suburban building for recreation, you need to draw up a project. The guest house with a sauna will become a real paradise for those who live in the city and sometimes prefer to go out to relax in the bosom of nature.

Features of a guest house with a sauna

The bathhouse, as a rule, is a building in which besides the standard amenities there is also a steam room. Here should be located: kitchen, bathroom, bedroom, water supply and sewerage system, as well as heating. Here you can not only relax on weekends, but also live throughout the summer period.

As a distinction of such a building from a full-fledged country house is that the guest building with a bathhouse has a steam room, a washroom, a font, and a dressing room. All this in the project takes more than half of the area. After the drafting of the project, it is necessary to purchase materials that must necessarily be ecological.

It should be taken into account when making a project: a guest house with a bathhouse should be heated during the winter cold, otherwise pipes may burst, which will disrupt the whole system if it needs to be started.

Features of design and layout

As a rule, guest houses are lined up and have two floors. Communications though should be, but they should be installed at a minimum. So, instead of a bath you should mount a shower cubicle, the kitchen premise should be small, as well as a vestibule, for all this a minimum of living space is allocated. Whereas when drafting the project with respect to the rest of the area it is necessary to distribute it as follows: 50% - a font, a therma, a dressing room, a swimming pool, a shower room, the same area will be occupied by the bedroom and the rest room. Finishing everywhere should be in one style.

For the sake of economy, you should not make an adjacent the steam room and a living room. This, though, will save a few square meters, but the decoration and furniture in the room will deteriorate.

The project of a modest house with a bath

If you are considering a budget project, a guest house with a bathhouse can be arranged as follows. In order to get a bathroom in which there will be both hot and cold water, it is necessary to equip the well in advance, where a special pump is supplied, equipped with a filter. In addition, you need a boiler, which can be replaced by a storage water heater. The latter is installed directly in the washing room, while from it it is necessary to take the pipes to the toilet and the kitchen.

The project of a house-bath 6х6 m

In order to build a house, the area of which will be 6x6 m, you can use the skeleton as the basis. The building will have a residential attic. Wireframe technology is inexpensive, and it is possible to realize the construction of such a house independently. In the outer walls it is necessary to cut in a couple of sticks, placing them in opposite directions. The internal and external walls must be securely fastened, and on top are tied with a board that is part of the upper strapping.

If you like this project, the guest house with a bath in the lower part should be attached to the platform, which should have a solid construction. This will make the frame more solid. From above, too, will have to install a solid platform, which will become part of the overlap. This method of construction has one important advantage, which is that after it is completed, you can immediately begin the finishing work. Cavity is not necessary, which is required in the case of erecting a house from a bar.

Features of construction of frame house-bath

If you are satisfied with the described project of a guest house with a bath and a swimming pool, you still have to observe the features of erection of the basement. In its quality, you can choose a tape base, which is not heavily buried. It is mandatory to make an additional transverse tape, which should be located between the therma and the washing room. In the inner space of the foundation, it is possible to equip an oversized technical basement, which is useful for mounting the water supply and drain system, arrange filters, all kinds of communications, and a hydraulic accumulator.

In view of the fact that there must be a guest room, a house-bath in the building, the project, the photo of which is presented in the article, should assume its presence, which indicates the need to designate all this in the drawing. So, to the word about the above, it can be noted that the walls of the walls, which are located outside, should have a width of 150 mm, but for internal walls, this figure should be equivalent to 100 mm.

In order to make the attic of such a building suitable for living in cold weather, its walls, floor and ceiling must be heat insulated, but you can use for this purpose basalt slabs. In this project, the floor of the first floor should be covered with ceramic granite, whereas the roof should be covered with Finnish tiles. The inner surface of the walls of such a house can be finished with a lining, but in the role of an exterior decoration blockhouse is suitable. As the most suitable staircase will be one that has tread stairs. The attic can be divided into two rooms, one of them will become a hall, and the other one will be a bedroom.

If such a guest house-sauna is built from a log, whose designs are presented in the article, then as dimensions of the steam room you can take into account the dimensions of 2x2.7 m, while the ceiling height will be equal to 2.55 m.

Thermal insulation of the house-bath

In order for the floors to be warm, under the cover it is recommended to lay the mats of the system "warm floor", the work of which can be adjusted. On the second floor you should put the convectors.

The device of the pool in the house

If the pool should be part of your country house with a bath, then its availability should be taken care of even during the construction phase, as the excavation should be prepared at the stage of land works. The first step will be digging the pit, which establishes a supporting element in the form of a bowl.

It is necessary to make waterproofing works. Only then you can proceed with the installation of a filtration and heating system. It is necessary to provide for the presence of a ladder, as well as a drainage system. If the guest house-sauna is built from the beam, the projects of which are presented in the article, a water disinfection system should be provided in the pool, and a ventilation system should be installed in the room itself. Do not choose a bowl that is too big, its area should not exceed 17-35 m ² , otherwise maintenance and construction will be too expensive.

As the most suitable depth of the pool stands the figure of 1.5 m. It will also be necessary to make a shallow part, the depth of which should not exceed 0.9 m. It is preferable to have a swimming pool in the basement of the building. Variants of accommodation above the ground floor are quite dangerous, because the guest house is not a capital building. The pool weighs considerably, it will put a greater load on the floors.

Alternative projects of guest houses

If you still have not chosen the design of the bath-house, the brick can form the basis of the walls. Only in this case it is necessary to take into account that the load on the foundation will be more significant. Works in self-implementation will require much more labor, and the construction itself will cost much more. The walls of the house will have to be additionally insulated, because they will not differ in heat saving. In this case, it is preferable to choose a project, which involves the erection of one floor, so that the second ene would place additional stress on the foundation. But the bottom is to be made recessed with a belt, it is best to discard the columnar if it is planned to install a pool on the ground floor.

Some choose projects of guest houses with a bath of foam blocks. Such a design will have a negligible weight and will not be distinguished by a not so high price because of the low cost of foam concrete.