AutomobilesTrucks

Overview of the car KrAZ-65055

Kremenchug Automobile Plant is one of the most powerful enterprises in Ukraine. It specializes in the production of commercial vehicles. In particular, these are dump trucks. One of these is the KrAZ-65055. For the first time the machine was born in 1997. Serial production of the machine continues to this day. What is KrAZ-65055? Technical specifications and not only - later in this article.

Appearance

The dump truck has a brutal massive exterior. The design is dominated by rough square lines. The machine has a huge iron bumper, halogen headlights and separate turn signals. The hood of the car, unlike the "Americans", is made of metal. Also, there are slots for ventilation under the hood space on the sides. And on top - a powerful cutout for the air intake. For the convenience of landing in the car provides a metal step. The same is also found on the front of the bumper - the truck is very tall, and climbing under the hood is quite difficult without it. The cabin does not have a berth. This machine is designed only for day operation.

As for the sizes, they are standard for a dumper of this class. The total length of the truck KrAZ-65055 is 8.35 meters, width - 2.5 meters, height - 2.87 meters. Also, the car has a high ground clearance. The ground clearance of KrAZ dump truck is almost 30 centimeters. This is not surprising, because the car is not designed for asphalt roads. This is a reliable and simple dump truck, which daily works in quarries and other places where there is no road surface.

Salon

Interior has not changed in the car since the 90's. So, here used the old dials, a flat metal panel and a huge double-spoke steering wheel. Seats have a limited range of adjustments and are devoid of lumbar support.

In terms of comfort the car is not designed for long-distance flights. The cabin is quite noisy and sometimes there is a draft. The cabin is designed for only two people (driver and one passenger).

Specifications

The Kremenchug plant closely cooperated with the Yaroslavl Motor Plant. So, for the KrAZ dumper there is a power unit of the YaMZ model 238 DE2. This eight-cylinder V-shaped diesel engine with a displacement of 14.9 liters.

The maximum power of the Yaroslavl engine is 330 horsepower. But, despite such a ratio of volume and power, the unit has an Nemer thrust. At two thousand revolutions almost 15-liter YaMZ gives out 1274 Nanometers of the twisting moment. It is this parameter that is important for such commercial equipment. After all, the dumper works constantly under high load.

Transmission

Coupled with this unit is a mechanical gearbox produced by YaMZ on 8 stages. Also, the car uses a dry single-plate clutch YaMZ-183. The design is quite reliable and withstands enormous loads.

Dynamics, consumption

Acceleration measurements of up to 100 kilometers per hour were not made (at least because the peak figure for KrAZ is 90 km / h). But in terms of fuel consumption, the Ukrainian dump truck is more economical than the "Tatar" (KamAZ-55111). For a hundred Yaroslavl motor consumes 34 liters of fuel. The tank capacity of 250 liters is enough for 735 kilometers of driving without refueling.

Chassis

Suspension of the dumper is strengthened, which made it possible to increase the load capacity to 18 tons. For comparison, at KamAZ this indicator is only 10 tons with the same layout. The drive of KrAZ 65055 is carried out on two rear axles (the wheel formula is 6 x 4). A dependent pivot beam is installed at the front. Such a design has been used on trucks since the time of the Soviet Union.

Behind there are bridges with springs of a balancing type. Vibration damping is carried out by hydraulic shock absorbers. They are located in front of the KrAZ 65055 model. Steering is complemented by a hydraulic amplifier. But even with it, drivers have to make significant efforts to turn the wheels.

Cost

The initial price for a new dumper in Russia is 2 million 700 thousand rubles. KrAZ is equipped with a powerful salon heater and air conditioning system. Also, the machine is resistant to temperature changes and can work reliably at -45 ° C. Therefore, the dump truck is actively used in all latitudes by many road and construction companies.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.atomiyme.com. Theme powered by WordPress.