In detail about what and how to dilute "Ceftriaxone"

How to breed Ceftriaxone? This question quite often interests those who at home make injections to themselves or their loved ones. However, experts recommend never using this drug without prescribing a doctor. After all, this antibiotic, which is prescribed only for certain diseases, can lead to the development of serious complications, including anaphylactic shock. Only the doctor who prescribes this drug knows what and how to dilute "Ceftriaxone", and also always indicates in what dosage it is required to be administered and how often it should be done. In addition, such a drug has a number of contraindications and side effects, which the doctor must inform his patient.

What happens if the injection is wrong?

Before you or someone starts injecting an antibiotic, you should know how to dilute Ceftriaxone. After all, if it's wrong to combine the components, it will not only reduce the effectiveness of the drug, but also increase the risk of such side effects as nausea, diarrhea, vomiting, cholestatic jaundice, pseudomembranous colitis, hepatitis, skin rash, swelling, itching, hypoprothrombinemia, interstitial Jade , etc.

Antibiotic agent "Ceftriaxone": can it be diluted with novocaine?

It is not recommended to use novocaine for breeding such a drug. This fact is due to the fact that such an anesthetic significantly reduces the activity of the antibiotic, and also significantly increases the risk of developing a dangerous and even fatal complication in the person - anaphylactic shock.

It is also worth noting that in no case should a diluted "Ceftriaxone" be stored for more than 6 hours. This is due to the fact that with prolonged storage, the antibiotic agent is destroyed, and its activity is significantly reduced.

How to breed Ceftriaxone? Before answering the question posed, it should be noted that it is strictly forbidden to mix the solution of the presented preparation with solutions of any other antibiotics. If you disregard this advice, it is possible to crystallize drugs, and in the future, and increase the risk of developing severe allergies.

The drug "Ceftriaxone": how to plant injections with lidocaine?

To dilute this drug, use only special water for injection or a 1% solution of lidocaine. Thus, it is required to take a disposable syringe (3.5 milliliters) and dial into it the above-mentioned anesthetic drug. Then, on the flask of the "Ceftriaxone" remedy, the aluminum cap should be pushed aside, and the rubber plug under it should be wiped with a cotton swab dipped in alcohol. After that, the capacity is required to pierce the needle and completely enter the contents of the syringe (lidocaine). At the end, the vial should be shaken vigorously before the powder is dissolved, and then pull the piston and again take the medicine into a disposable device.