How to wipe stitches on tiles: practical tips

The most difficult areas of repair in most cases are a bathroom and a kitchen. It takes a lot of expensive materials, as well as time for the entire list of necessary works.

In addition, beginners often have questions about how to wipe the seams on the tile, since the accuracy of this operation largely depends on the attractive aesthetic appearance of the room.

What you need to do before you start

Bear in mind that there is no need to hurry before the start of this important event. Fresh tiles should "stick" to the wall for at least a week. Yes, modern types of glue allow to make grout already on the fifth day, but it is still better to wait longer. And even more so do not do it the next day after packing. By this, by the way, many "shabashniki" are famous.

We clean

Before you wipe the seams on the tile, you need to carefully clean its edges. Remove dried pieces of glue as cleanly as possible, remove dirt and the whole collection of fingerprints. Do it handy with a sharp clerical knife, immediately removing all the dirt with a vacuum cleaner. After that, the stitches are carefully wiped with a soft sponge.

We prepare grout

Follow the instructions on the packaging, prepare the mixture. Most often, about 300 ml of water is taken per kilogram of trowelling.

To do this, take a container of sufficient volume, water is poured into it and mixed with a wooden stick until the funnel is formed. A mixture is poured into it in a thin stream. You need to mix it until the moment when it gets the density of good sour cream. After that, we leave it alone for five minutes, after which we again interfere.

We are working!

Since the joints on the tiles need to be cleaned with the utmost care, a rubber spatula should be used. Surplus is washed from the edges, again pressing into the seams. When they are completely filled, we remove the surplus material again, moving to the next section of the work. If you do this for the first time, it's best to try your hand at a small section of the wall.

We are waiting for about 20 minutes, then proceed to zamyvke. By the way, before you wipe the seams on the tile, do not forget to buy enough soft sponges for washing dishes, as they will need repeatedly!

Wetting and carefully wringing one of them, gently wash off the remains of the trowel from the seams. It is very important not to rush and as carefully as possible to squeeze out the sponge, otherwise the dried water will form incredible patterns on the tile.

So we found out how and how the seams between tiles are erased. Many workers stop there, but we will go to the victorious end, having done our job perfectly!

Shaping of seams

To do this, you need to pick up a small piece of the hose from the dropper or something similar that will fit perfectly into the seam. Pushing the selected tool into it, you will form an ideal pattern of all the seams on the tile. This work is a little boring, but the result turns out to be extremely beautiful!

By the way, how much does it cost to wipe the seams of tiles? It all depends on the composition you use and your aesthetic preferences. So, the cheapest grouting costs about a hundred rubles for a couple of kilograms, whereas a kilogram of the finished mixture can have a cost five times higher.