How to make and install a lifting gate with your own hands?

In order to build a lifting gate with your own hands, be sure to choose the right time and get the necessary material. This design is very popular, as it does not require additional space near the garage, and it is quite simple to care for.

What kind of lifting gates are there?

So first of all you need to understand the type of construction that you will be doing. For example, the most common type is the sectional gate. The design is the articulation of a certain number of segments that are screwed to the movable panels.

To complex structures are lifting and turning gates. With their own hands to build them a little more difficult. The fact is that the construction rises entirely and hides under the ceiling. Of course, such a product has a lot of weight.

When you are going to make the lifting gates with your own hands, prepare the following materials and tools:

- metal for frame construction;

- material for the construction of the fabric, which fastens firmly on the frame;

- Lifting mechanism (it should be purchased at the store);

- Screwdriver, drill, Bulgarian, level and tape measure.

Features of the construction

Before you start, you must draw a drawing of the structure on paper. At this stage, the width and height of the garage are taken into account. You also need to map out the area in which the drive will be located.

The first steps involve the construction of a future structure. The height of each section is 50 cm.

It is very easy to assemble the lifting gates with your own hands. Panels for garage linen are desirable to produce from quality components: strong plastic, galvanized steel, wooden slats. It all depends on the overall layout of the room, your taste, and the amount of finance that you can spend. The sections are then screwed to the prepared frame.

In principle, it is not difficult to build the lifting gates with your own hands, but you should not forget about some nuances. For example, a canvas is desirable to do double. And between the facing material you need to put a thin insulation, which will protect the room from the cold.

Please note that the outer part of the panel must be protected from the effects of atmospheric influences. For this purpose, a special film is used, which covers each segment. The lower part of the structure must be equipped with a sealant.

Mounting gate installation features

After the canvas is ready, you can proceed to strengthen it in the garage opening. Install the lifting gates with your own hands should be neat and accurate. First you need to mount the frame of the structure. Use the level. Secure it with an anchor bolt.

Further, vertical (lateral) and horizontal (to the ceiling) guides are mounted, along which sections will travel. All voids should be filled with foam. Now you can fasten the prepared panels to the frame. Connect them with the help of hinges. Naturally, it is necessary to pay attention to the system of fixing the gate under the ceiling, so that they can not fall.

Lastly, the installation of an electric drive, alarm system and anti-burglary system. Screws all the necessary hardware, after which you can test a new design.

Now you know how to build a garage lift garage with your own hands.