How to make a line in the "Word" for signing: a few simple ways

As you know, working in Word basically involves the use of office text documents, contracts, official forms and forms, where sometimes you need to leave an empty underlined place for the signature. In general, only this user needs may not be limited. The scope of such underscores is much broader. But now it will be about how to make a line in the "Word" for the signature. In the editor itself, you can use a few simple tools, which each user knows.

How to make a line in the "Word" for the signature? The simplest method

Everyone who has ever encountered a Word text editor at least once knows that a regular line can be created using keyboard symbols.

To do this, you just need to hold down the Shift key, and then the hyphen key ("-"). In this embodiment, the line may have an arbitrary length. The main thing - do not get carried away, and then when you go to a new line, it will automatically be converted to a more fat and the full width of the sheet.

Using tabs

Another simple way to solve the problem of how to make a line in the "Vord" for a signature, involves the use of a so-called tabulator, in simple terms, the Tab key.

To create a continuous line, you must first set the underline by clicking on the corresponding button on the main panel (it is marked with an underlined letter "Ч" in the Russian version of the editor), or use the Ctrl + U combination, which is the same. Now it's a little thing. You just need to hold the Shift key and press the tabulator several times and create a line of the required length. Here it is worth noting that this line has a fixed length (this depends on which tab setting is set in the parameters).

How to make a line under the text in the "Word" using the table?

The above methods, although they make it possible to create the necessary components in the form of lines, nevertheless, it is impossible to enter text over them.

To create an empty underlined space, you can use tables that are divided into several cells. For example, in the case of three cells, the text can be entered on the right and left, and the center will have an empty space for signing or for entering additional text.

To make it look like a line, all the boundaries of the table need to be removed, leaving only the lower border on the desired cell. Here it is worth paying attention to the fact that when you insert a table in the middle of the text (when it is located both above and below), vertical indentation will automatically be increased between cells, which may lead to deterioration of the readability or appearance of the document. Therefore, it is recommended to make such insertions at the end or use empty lines with the input key pressed (by type of separable paragraphs).

Graphic Tools

Finally, the problem of how to make a line in the "Vord" for a signature can be solved with the help of drawing tools that are available in any version of the editor. To do this, apply the appropriate section, which selects the tool for drawing a straight line.

In the text it is enough to place the cursor in the starting point, then move it with the left mouse button in the end position and release the button. You can change the length of the line by selecting the desired element with the appearance of the four-point icon and setting the pointer to one of the points until a double arrow appears. After that, the change is made by stretching or squeezing.

Instead of the total

In principle, as can already be seen, creating a continuous line for signing is not so difficult. Some, however, try to use the usual "-" symbol without holding down the Shift key, which only leads to the fact that the line is dashed, is positioned in the vertical positioning strictly in the middle and just spoils the kind of document. Therefore, it is better to use the above methods. If you do not need to enter text on empty space, the keyboard symbol or tabulator for lines of the same length is fine, but if you need to enter additional characters or letters without a table, you can not do.