How to make a corner of the ceiling skirting: a creative solution to the problem

A rather difficult task is the gluing of the ceiling skirting. Corner alignment and their docking is the main problem. Below is a description of how to make the angle of the ceiling skirting.

Let's start with the tool that we need for this. It is enough to be a stool and a construction knife. As a rule, it is necessary to trim the plinth for internal corners. At first glance it seems that everything is very easy, but when a new skirting board turns into unnecessary trimming, you begin to understand that not everything is so simple. Let's understand how this is done.

How to cut the angle of the ceiling skirting board?

The simplest and quickest remembering option is that the plinth is applied to the top corner so that it is to the left of it. Hold the fingers of the surface of the baguette, which we will glue to the ceiling. We put the plinth in the stool. On the bottom of its wall should be the surface of the bar, which you hold with your fingers. Knife cut off the corner, turning it to 45 ⁰ so that its end looked left. The left-side part of the plinth is ready. Now we cut the right-side part, i.e. The one that will be to the right of the inner corner.

How to make the angle of the ceiling skirting in this case?

Applying to the corner of the bar, note that its surface, which will be glued to the ceiling part. We put the workpiece in a chair, pressing a surface to its lower wall, which we will glue to the ceiling. Cut the corner 45 ⁰ , with the tip of the knife should be directed to the right. Cutting off both sides of the baseboard, we apply them to the inner corner to check the accuracy and accuracy of the cut.

If the angle of the room being repaired is flat, then when we reduce the skirting, we will not see the gaps. If the wall with errors, plinth cut, then glued.

But there are also external corners. How to make the angle of the ceiling skirting in this case? Let's consider this option. Though it is necessary to cut skirting boards for external corners of premises much less often, than internal, but all the same it is necessary to do it correctly. It should be noted that if you have learned well how to join the corners of the ceiling skirting with an internal angle, you and with external problems will not. This method is the opposite of the previous one. We mark the beginning of the corner on the skirting board. Important is the fact that at the time of forming the outer corner on the baguette, the inner corner must already be ready and adjusted. It's clear. We prepare for cutting the left from an external corner a plinth.

Attaching it to the wall, mark the side glued to the ceiling. We lay the plinth with this part in the stool so that it lies on its lower part. And also pressed against the far wall of the used device. Knife at an angle of 45 degrees cut the bar. The tip of the knife should look to the right at the same time.

We glue this part of the corner. It is important that the short side of the product is not shorter than the corner of the wall. If it is a little longer - not scary. In the same way, we prepare the right-hand side of the plinth of the outer corner. We control their docking and glue them. Now that you are aware of how to make the corner of the ceiling skirting with the inside and outside of it, let's consider another interesting option.

How to make rounded corners?

There are non-standard rooms with non-standard angles. Given the curvature of the angle, cut small segments. We cut each of them from two sides with the help of a chair and at an angle. We glue their joint into the joint. The initial segment of the rounding is glued to the straight plinth on one side, and the final one to the straight skirting board on the other.