How to configure a network between two computers: an instruction for beginners

Today in this article we will consider the question of how to configure the network between two computers. Perhaps you have already tried to do something like that. The article will describe the simplest method for performing this operation. At once it is necessary to say that you do not need to have any in-depth knowledge. It is enough to follow all steps of the instruction in order. So, next you will learn how to configure the network between two computers.

Preparation

In this method, only one component is used. Namely - "twisted pair". This cable is quite inexpensive, and it can be purchased at any specialized store. As a rule, its minimum length is approximately 1.5 m and can reach 90 m. First of all, you need to purchase just such a cable. Also, to create a network between two computers, a network card must be installed in both PCs. All components can be purchased at any electronics store. If all the elements are available, then you can proceed to the very instruction itself.

Instructions

Turn on both computers and connect them with a cable. The ends of the wires must be connected to the network card. After these actions, a new local network will appear on both PCs . Now you need to make some of its settings:

1. Go to the "Control Panel" - open the "Status View Window ..." - "Change Adapter Settings".
2. Here you will see a window where you will see all the connections that are currently in the active state.
3. You need to select "Local Area Connection". Click on the shortcut with the right mouse button, then select "Properties". If you have several of them, you in most cases need to choose that connection, which after the name will have a figure with a larger denomination.
4. Find the option "Internet Protocol version 4 (or 6)". Select it and click the "Properties" button.
5. Enter the new IP address in the format 192.168.XX The first two values always remain unchanged. The last two can be changed at will. It is recommended not to use those IP-addresses, where the values end in figures 1 or 2, since they are used by standard means.

additional information

Previously, you learned how to set up a network between two computers, but in some situations you might need to connect more than two devices. In such cases, you can not do with only one cable. You will need to purchase a special router. This device allows you to distribute the network among several PCs. The number of connected computers is limited by the number of slots on the router. It is possible to use several similar devices at once to connect more PCs.

Conclusion

There is nothing difficult in making a network between two computers. As you can see, you will need a minimum investment of funds and a little time for setting up the system. The main thing is, before you start the connection, check that the network cards of the computers are working. You can do this through the standard tool "Device Manager". If the board is present in the list, then everything is fine. I hope you understand from this article how to set up a network between two computers.