How to close the pipes in the toilet beautifully and correctly

In standard urban apartments, centralized hot and cold water pipes, as well as a sewage riser pass in the toilet or bathroom, so when repairing these premises, the question of how to close the pipes in the toilet is quite serious. It is impossible to build a solid wall completely covering the water and sewage communications, in no event, since water tap-offs are equipped with filters, valves, water meters, direct access to which is mandatory. In addition, it is desirable that there should be an approach to the joints of pipes: these are the weakest points in the system, from which leaks usually begin. Therefore, from the outset, it is necessary to consider several options for designing the rear wall of the toilet in such a way as to ensure the approach to all sites and devices, and also that the appearance of the wall corresponds to the general design of the bathroom.

There are several solutions that answer the question of how to close the pipes in the toilet correctly and beautifully.

1. Manufacturing and installation of a completely removable wall made of particle board, plywood or Plastic. The wall is attached to the frame by means of screws, magnets or special latches in such a way that it can be removed at any time. The surface can be painted, wallpapered with wallpaper or other suitable material in color. Installing such a wall, we provide full direct access to all systems, but still it is quite inconvenient and troublesome because of the cumbersome design.
2. More harmonious and modern version: close the pipes in the toilet with a roller shutter. Installed on the entire width and height of the rear wall, it, just like a false wall, provides unlimited access to the riser, and it is easy to climb and lower as necessary. That's just noise insulation it is not ideal, so all the manipulations of neighbors from above will be well audible in your bathroom.
3. In modern building technologies, the question of how to close pipes in the toilet is solved by partially sewing the wall with the manufacture of a convenient wide opening (or even two) for a convenient approach to the necessary nodes. The wall is either laid with foam blocks 5 cm thick, or it is sewed with two layers of moisture resistant gypsum board on a frame made of wooden racks or special metal profiles. You can sew and plastic panels, but the noise insulation will suffer.

Sewing this way the wall, you need to determine what will be closed our technological hole. Usually it occupies almost the entire width of the back wall and 60-80 cm of its height. You can choose the same roller shutters of smaller size, suitable for color, or metal blinds. A good solution is to install an overhead hatch, which is also convenient to use.

Recently, so-called hidden technical hatches are increasingly being used. The robust mechanical frame of such a structure guarantees the reliability of its installation and use, and the latest modifications allow opening the hatch with a light pressure of the palm. Advantageously, the hidden hatch differs from the design point of view: closed with ceramic tiles, it becomes almost invisible against the wall. Thus, the problem is solved, how to close the pipes in the toilet, without disturbing its overall aesthetics.

In modern large flats of monolithic buildings, the question often arises of closing the pipes in the bathroom, which pass through the floor and can not be deepened for technical reasons. Here, also comes to the aid of the construction of a box of foam blocks or moisture resistant gypsum board, which is often faced with ceramic tiles. So any problem is solved, if we consider it professionally and from different points of view.