How do I clean the carburetor? Step-by-step process

The carburettor is the main component of all cars equipped with carburetor engines. This spare part plays a crucial role in the fuel delivery system. It is from its good condition that it will depend on whether the car will start or not. When this part is clogged, an excessively "rich" or "poor" mixture may enter the combustion chamber. For the motor, neither one of the other liquids are ideally suited. Therefore, in order to avoid such trouble, you need to carefully monitor and remove dirt from this part. But how to clean the carburetor? We will deal with this issue today.

Is it possible to produce this process independently?

Of course you can. All work does not have any intricate or difficult stages, so even a beginner can cope with cleaning. Moreover, in time this process is not so laborious that it will be faster to do everything yourself than drive a car to a car service.

Instruments

Before you clean the carburetor (VAZ 2109 or GAZ 24 - it does not matter, it does not change the essence of the matter), you should prepare all the necessary tools. For work we need an empty container of 1-2 liters, a screwdriver, a minimum set of spanners and socket wrench, as well as a special solvent.

Where to begin?

Before you clean the carburetor VAZ, Toyota or BMW (from the car brand the work stages do not change), you must first remove it. This we now and will. So, first of all we find this part. On all machines it is located under the hood near the air filter. On it you will see a cover that holds the carburetor in the system. First, unscrew the 4 bolts and detach the gas cable and the fuel supply hoses from the part.

After the given spare part is dismantled from the car, it is necessary to disassemble it. To do this, remove the solenoid valve, the jet and the axis of the floats. When removing the cover, you will see a rubber gasket. But before cleaning the carburettor, carefully inspect the condition of the seal. If it is damaged, replace the gasket with a new one.

Next, unscrew the fuel valve and bolts (on all machines there are four of them), which secure the launcher, and then its lid. We unscrew the plug and at this stage we extract the filter.

Since you can clean the carburetor yourself, we do not carry this part on the SRT. After dismantling, we take a special liquid to clean the carburettors and pour it into a small saucepan. Then we lower there the clogged element and put the container for a day to be cleaned. Boil pr And this does not need anything. The temperature of the filter and solution must be room temperature. The next day we remove this element from the tank and with the help of gasoline we wipe the dark plaque, which was formed there in 24 hours. We are waiting for everything to dry up, and we proceed to assembly. The installation of this part is carried out in the same manner. And one more important tip: do not forget about the seal. If it cracked, immediately replace it with a new one.

So, we figured out how to clean the car carburetor yourself.