Electronic bait for fish with their own hands - much more economical

In our time, electronic bait for fishing, working on the principle of sound vibrations, has long been a rarity. They enjoy a fairly large number of fans of "quiet hunting". It is known that the fish always shows some attention to all kinds of signals emitted in the pond.

Principle of operation

Modern electronic baits operate much more efficiently than various traditional bait, since they attract fish at the same time with four influences: both light and acoustic, and mechanical with electromagnetic. Sound fluctuations in the water extend to a sufficient distance - up to a thousand or more meters. Once in the zone of action of this device, the fish instinctively tries to get as close to the source of such "pleasant" signals for it and immediately falls on the hook. In this case, a large fish reacts even to low-frequency sounds, which emit small crustaceans in the pond. When a flock of crayfish feeding creates more high-frequency vibrations, this signal is collected by a larger inhabitant of the pond. The range of sounds in the pond is from two hundred to thirteen thousand hertz. Each species of fish produces fluctuations in its frequency. As a rule, the same frequency attracts her. Therefore, the fishermen are determined by the frequency of sound produced by the flock, the type of fish and its number.

Device

Electronic baits for fishing are made so that the device automatically switches on and off as after immersion in water, and after extraction from water. They are equipped with a bridge designed for use in water bodies with low electrolytic conductivity. The source for food, thanks to which works both bought in a specialized store, and self-made electronic fish bait, is a rechargeable internal battery. Usually its capacity is enough for two hundred hours of continuous operation.

Electronic fish lure, made by own hands

The design of this device, which attracts prey on fishing, is a sound electronic generator. It can be placed in a small, suitably shaped box, for example, in a conventional soap dish. A generator having a sound-emitting part immersed in water is assembled on two transistors. At the same time, a dynamic loudspeaker with a voice coil of resistance at seventy-five ohms can serve as a load for it. With the help of two variable resistors in the device, it is possible to change the frequency of sound oscillations. So the electronic bait for fish, made by own hands, can select the sounds most appealing for a particular fish species. This is what made this device attractive for fans of specific fishing.

Design

Schemes of electronic fish lures suggest the use of both low-power low-frequency semiconductor transistors MP111 or MP113, as well as any KT315 high-frequency transistors. To receive a sound-emitting loudspeaker, you can use any phone capsule, for example, DEM-4M. The membrane can be sealed with a waterproof film or sealed with silicone or epoxy.

The loudspeaker must be connected to the main circuit by means of a wire of the necessary length, so that during fishing it can be immersed in the depth to the depth necessary for effective fishing. In general, the design is very simple, cheap and affordable. Therefore, the electronic bait for fish with their own hands is made by many fishermen, the more so as the costs for it are small enough compared with the relatively expensive factory ones.

Inside the box, you need to put both a battery and a resistor with a beak, for which you can put marks, so that, in case of successful biting at a certain frequency, next time be able to again adjust it. Electronic fish bait, made by oneself, although it consumes a small current (so the battery lasts for a long time), but has one drawback: the volume gradually decreases. Selection of the frequency should start with a lower one: the resistor must first be in the extreme position. Then the experimental method needs to slowly add the value of the radiation of the dynamic head. If you do not have a suitable power switch at hand, you can simply disconnect the battery after the end of fishing.

Advantages of electronic bait

Many fishermen, for whom the electronic fish lure, made with their own hands, is an opportunity to save, do not spend any more money and time for preliminary training. Instead of cooking porridge or grinding bread, they simply throw this compact device into their backpack and go to the pond.

In addition, even self-made electronic bait has a large impact zone compared to other ways of attracting production. If the biological feeding of fish senses a maximum of five, then oscillations of the generator they "hear" for hundreds of meters, sailing to the sound, even from the other end of a small pond.

Most electronic baits, including self-made baits, attract extraction by several types of signals, for example, light and acoustic, etc., while ordinary bait affects only taste buds.