Catching on the feeder on the current is fascinating, but difficult

Many anglers will confirm how fascinating catching on the feeder. At the same time, the excitement increases doubly, because it gives the opportunity to show this potential to the end. A fast flow, which at times hinders the holding of the feeding trough, nevertheless renders a service, distributing the lure, which makes it possible to attract fish from the largest possible water area.

However, it's not always easy to catch on the feeder. On the flow, which is very strong, you need to use feeders that weigh more than eighty grams. And if the average flow of problems with lure almost does not happen, because it does not demolish and is always delivered to the same place, then at high water speeds it can be much more difficult to achieve, even knowing all the features of this kind of fishing.

But even on very fast channels there are places where the flow is much weaker. It can be places with a back stroke, bays, whirlpools, turns. All of them can be very catchy, since most fish that are caught on the feeder on the current feel not very good. And this is not surprising, because in this case they need to make a lot of effort to resist the flow of water, with a strong jet it is more difficult to find food.

It is not always possible to find places where the current will be at least average, so you have to be content with what is. The most common difficulty encountered by an angler is the differences in relief and the demolition of complementary foods. And many prefer to give up this kind of not very "quiet" hunting.

However, there are anglers for whom catching a feeder on a strong current is not a problem. They know several ways to withhold complementary foods. The first is a change in the weight of the feeder, which is achieved mainly by adding a weights. In addition, a thinner line is used. But there is one more method: to raise the feeder as high as possible, so that there is a minimum amount of fishing line in the water.

Some anglers say that catching on the feeder, on stream or in calm water, will be successful if you use triangular feeders with bottom hooks.

In addition, you need to know that for each type of production for this type of fishing you need to take a special bait. For example, catching bream on the feeder, especially in the current, implies a complete rejection of such a complementary meal, which has even a small dusting fraction. The mixture, falling into the water, should lie down in a dense layer, without rising and not being carried off by a plume down. Otherwise, the feed table will be smeared and will attract numerous small fishes.

Bream is an extremely delicate prey, preferring an abundance of biscuits or active biscuit, as well as sticky large fractions, which, by their properties, will enable the fish to spin around, rummage and choose the favorite treat you can buy at any specialized store.

For fishing on bream, you can use different erections. This can be an asymmetric loop, and a helicopter, two nodes and so on. However, the optimal feeder gear, according to experienced fishermen, to catch not only bream, but also other fish, is the paternoster.