Installation of a water pipe in the country or in a private house

Many people decide to live in a private house, as this allows them to be much closer to nature, water and clean air. However, if the greens and air immediately surround us in the suburban areas, then with water supply the situation can not remain at the level of the well or well for a long time, as it will want some familiar level of comfort. It is then that you will need to drill a well, and also install a water pipe. We are talking about drilling an artesian well, which guarantees the provision of water to all the needs of the owners, not only in the home, but also on the site.

Before starting the installation of a water pipe in a private house, a detailed project should be formed, where water consumption and wastewater calculations will be made, as well as water intake points. In fact, water consumption depends on the number of people living, as well as on the number of placed sanitary devices.

After the well is ready, water is raised by means of a downhole pump. In the house, water is supplied through pipes of low pressure polyethylene, the diameter of which can be 32 or 40 millimeters. Their service life will be at least 50 years. Installation of water pipes is carried out with the obligatory observance of all the most modern requirements.

The preset pressure in the water circuit at the highest flow rates, as well as the pressure limitation during the absence of flow, is maintained by means of special automation.

The automatic unit is best installed in the house, which guarantees the convenience of its maintenance. To install it, one square meter of square is enough. In the event that the house has no place for it, a special room is used.

Installation of a water main in the house provides for separation into cold and hot water supply after filters for water treatment. The water can be heated by means of a direct heating boiler or by indirect heating in a boiler, which allows the water intended for household needs to receive heat from a closed heating system.

Installation of the water pipe can be carried out using two types of pipes: polypropylene, which are solid pipes, suitable for open laying; From cross-linked polyethylene which allow to carry out the latent lining in floors, walls, and also in heaters. The second species is able to withstand high blood pressure. By the diameter of the pipe can be from 16 to 32 millimeters.

Installation of water can be carried out using two types of wiring: tee or collector. In the first variant, the location of the cranes for each device is assumed. In the second type, all the cocks are placed in one or more lockers, but this method involves an increase in the pipe footage.

All work related to installation, it is necessary to produce at an ambient temperature of at least +10 degrees Celsius, as the pipes become brittle at a lower temperature. In winter, installation work can be carried out using a heat gun. The remaining nuances of this entire process require separate consideration.