How to properly stick the wallpaper

One of the most simple and affordable ways to change the interior of a room is a wallpaper sticker. Despite the fact that the process of gluing itself is simple enough, many make mistakes. As a result, the canvas can begin to peel off, and joints become visible even with a cursory examination of the walls.

Surface preparation

The final result depends on the foundation and its initial state. The complex of measures is to clean the walls of the old coating and any contamination. In the event that the surface is wet, then you will notice it on concrete. The fact is that with an increased level of humidity, the wallpaper sticker is not allowed.

Next, level the walls (if required) and conduct the putty. After all the preparations, you can start wallpapering the wallpaper. First, measure the height of the wall and measure the first sheet. If there is no drawing, or you chose an abstraction, then there is no need to make allowance. In the presence of an image, we first join the boundaries, and only after cutting off the next canvas. So, cutting all the rolls, you will finally complete the preparatory work.

Now close all the windows and doors (exclude the possibility of a draft), do a portion of the glue and start work.

Dilution of glue

We advise you to use those compounds that are recommended directly by the manufacturer. This is due to the fact that the wallpaper base is different. And one glue may not come up. For example, a sticker of vinyl wallpaper is effective only with certain solutions. If you use a composition for paper sheets, then literally the next day the sheets will be peeled off.

The rules for the preparation of glue are indicated on the packaging. They just need to be done.

Glue the wallpaper

Dense sheets are glued to the back, thin - butt or overlap.

The first cloth must be applied extremely carefully, using a cord with a plumb line. After that it is enough to follow this landmark. Places of joints, it is desirable to grease the corners after the application of a wallpaper with a PVA brush.

Most often, glue is applied to the wallpaper from the top to the bottom, and then edges or walls (if you have non-woven wallpaper). Next, the sheet is left to impregnate according to the instructions (10-15 minutes). If the canvas is not sufficiently impregnated, then air bubbles form on the walls.

Prepared leaf is applied to the docked side, keeping it from above on the center. The band must be pressed with a soft roller, spreading the sheet from the center to the edges. Especially carefully smooth the seams, and remove excess glue with a sponge or a rag.

Ready joints are periodically inspected and smoothed. Bubbles that could not be removed by roller, pierced with a needle and pressed.

If you want to stick the wallpaper behind the batteries or pipes, then all the joints are especially carefully smeared with glue, and in the places of hooks we make accurate cuts. In the presence of plastic slopes with a flexible corner of the edge of the wallpaper must be removed under it. At the doors and windows, the edges of the wallpaper are cut only after drying.

Thus, the wallpaper sticker is a whole complex of works, which is easy enough if you follow the instructions and rules. In conclusion: if you chose monophonic canvases, you can buy decorative stickers on the wallpaper. Such a decor is available to everyone, while it does not require special skills and knowledge.