How to make a kiln on waste oil by hand?

A large number of people often face the problem of heating a greenhouse, a garage, one of the rooms of an unfinished villa and so on. Of course, the solution to this problem may well be the purchase of special heating equipment. But is it not better to make a kiln on waste oil with your own hands? Moreover, it is quite simple, and from the economic point of view it is much more profitable than buying equipment in the store.

So, let's give a brief instruction for creating such a heating element. In fact, this furnace on waste oil consists of only four main parts. This is a chimney, two tanks and a connecting pipe for these tanks. And it is worth noting in advance that the lid of one of the tanks (top) should be reinforced, because it will burn most quickly.

Also, if you create a kiln on waste oil with your own hands, you need to consider some of the features of the connecting pipe. Do not use a pipe with a diameter of less than 100 mm. And its minimum length should be 400 mm. In general, it is highly desirable that this same length be about four times the diameter. Through the whole surface of the connecting pipe, holes with a diameter of 9 mm are drilled. Such holes need about 50 pieces.

Also, when making a kiln on waste oil with your own hands, do not forget about the chimney, which again has some special features. It is quite logical that it should be located above the upper capacity. It should be taken into account that its base must necessarily be heat-resistant. As for the further length of the pipe - it can be performed Even from tin. By the way, regarding the length, it is desirable that the hood for smoke is up to 7 meters high. But if necessary, you can reduce it to four, not less than that. In some cases, in order to increase heat dissipation, such a pipe is inclined at a particular site. But at the very end it must be strictly vertical, so that the wind does not blow it. If necessary, you can make a special cover that will protect the chimney from getting into it rain or snow.

Now the oven on the waste oil is almost ready by hand. It remains only to understand the bottom capacity. This capacity, as well as the upper one, is covered A cover to which the connecting pipe and the upper container are welded. There must be absolutely no gap between this cover and the capacity itself. But it is necessary to have an adjustable hole for refilling with oil and for accessing oxygen. And do not forget that the entire structure should be placed on special legs. In general, everything, the furnace is ready.

Finally, I would like to note that such heating on waste oil has some significant advantages. First, this is the aforementioned economy, because working off is really inexpensive. In addition, the operation of such furnaces is considered to be environmentally friendly, they do not smoke at all. Well, the mobility of equipment. The oven is very simple, easy to disassemble and transported.