Gate metal hinged - an excellent choice for your garage

The metal gate is very popular today. This is an integral part of any fencing that is installed around a private house, backyard, warehouse or industrial zone. Differ from the wooden gate designs, the metal is simple in maintenance and durability. Even the most strict and discerning buyer will appreciate the variety of design of such products.

Design features divide the gate into:

- swinging;

- recoiling;

- Sliding.

Traditionally, swinging doors are the most common in the construction of a garage. This product is made of two flaps, which are attached to the support posts of the door opening with the help of loops. Hinges can be made from bearings or use hinges consisting of two bushings connected by an axis. One end of the axle is pressed and the other end rotates freely on the other bushing. The material from which the gate is made of metal can be very diverse: a sheet profiled, sandwich panels, corrugated board. More and more often, forged gates began to occur . These are very beautiful and reliable products.

Advantages of swing gates:

- easily inserted into the finished doorway;

- do not require special care;

- installation of automatic devices and electric drive is possible;

- can be installed around any object;

- materials for manufacturing are not subject to corrosion;

- provide a reliable protection of the site from foreign penetration;

- low cost.

Although they are the easiest to manufacture and install, but have some disadvantages:

- the doors can be closed from the wind, which leads to damage to vehicles;

- a snow cover, even insignificant, can prevent the opening of the gate.

Metal garage doors are made mainly bivalves, but they can be made single-leafed. In the second case, the leaf can sag because of the torque. Because of the snow cover in the winter, it is desirable to set them 100 mm above ground level for free opening. In the panel you can build a gate. The basis of the construction is a metal frame, sewn with a sheet.

The dimensions of the garage doors are chosen for design reasons, based on the condition of comfortable entry of the car. They are made slightly less than the height of the front wall of the building. Too high or low metal gates will look disproportionate and in terms of aesthetics look not quite beautiful.

The width of the gate, on the contrary, should be maximum, in order to avoid the inconvenience of entering and not accidentally damage the car. If the garage is not too wide, then the opening is selected from the dimensions of the car, about a meter wider.

You can purchase as ready-made, with good performance, reliable and durable products, and make custom-made metal gates. The price depends on the size, design features, quality of the lock, the presence of wicket, heat, noise insulation and other parameters. Approximately it starts from 12,500 rubles.