How to Install Roof Ceilings with Your Own Hands

Mount the ceilings with their own hands is not difficult. To begin with, you need to pick up all the necessary tools and materials. So, you need a metal profile, from which a frame for fixing the finishing material will be built. Of course, you need to purchase and reiki. They are usually made of aluminum. From the tools should be stocked with a hammer, a perforator, a screwdriver, pliers and scissors for metal (the profile will have to be cut).

It is very profitable to construct lath ceilings with your own hands. First of all, this can be done without attracting specialists, which will significantly reduce the cost of the structure. And the racks are light in weight. The presented material can also have a different color, so it can be used for finishing any room. The only drawback may be that the construction of such a design is best done in rooms with high ceilings.

Rack ceilings with their own hands are built in such a sequence: marking the base surface, mounting the metal frame, screwing the laths. So, first you need to calculate the amount of material you need. Depending on the manufacturer, the slats and crossheads may have different lengths. In any case, you need to buy a little more material than you need. This will allow you to repair the ceiling without problems in the event of a breakdown.

Now you need to make a markup of the main surface. This is done with a simple pencil and a level. In this case, it is necessary to take into account such dimensions: the distance between the traverses should be a maximum of 1.2 m, the distance from the wall along the perimeter should be about 30 cm. Further, it is not difficult to build the ceiling ceilings with your own hands. During the marking, it is necessary to provide the location and number of spotlights. Now proceed to mounting the metal structure along the lines drawn. In this case, note that the distance from the main surface to the finishing material should be 1 cm more than the size of the luminaires.

Installation of the lath ceiling with your own hands must begin with the fastening of the main and guide profiles. For this you need to use dowels. Now you can fix the guide elements. The last stage of the installation of the frame is the attachment of traverses and suspensions. Without them, you can not attach the slats. Once the metal structure is ready, you can begin installing the slats.

Suspended lath ceilings with their own hands must be done accurately and accurately according to the scheme. The straps to the guides are fastened, but they do not need to be screwed, since the main elements have special latches. Some trims will need to be cut slightly. Before installing the material, remove the protection layer. The first elements are preferably fastened at the edges, after which the level of the suspensions is regulated. It should be noted that the slats can be joined closely to each other, or you can use special inserts between them. It depends on your taste and the chosen manufacturer. Good luck!