How to build a bath with your own hands from a bar? Basic moments

Construction of a bath is a very labor-intensive process, which requires thorough preparation. It is very important at the same time to be guided by technological requirements, otherwise the bath will not be warm and reliable. If you thoroughly approach the question of how to build a bath with your own hands from a bar, you can create a whole park complex with flower beds and a pond on the site.

What should be considered in the construction? First of all, it is necessary to think about the creation of a pillar-pillar foundation. For this, concrete blocks are usually used. In order to build a bath of timber, you need to lay the blocks on the support. The distance from the ground should be about twenty centimeters. If you plan to make a large bath complex, you should stack four blocks on each side to the support. The distance from the ground should be about thirty centimeters. Naturally, it is necessary to pay attention to the ground and the landscape of the place where the building will be located. It is necessary to understand that under the blocks there should be a special pillow made of sand and crushed stone, the thickness of which will be approximately equal to twenty centimeters.

So, all the earthworks are finished, laying the foundation is made. Now it is necessary to talk in more detail about how to build a bath with your own hands from a bar. First of all, it is necessary to lay on the base about two layers of roofing material. After that, you can begin to lay the first crown. Also at this stage it will be necessary to immediately lay all the sex lags and map out the places on which the partitions will later stand. In order to give the bath a fortress, it is necessary to saw under all the future partitions of the lag from the bar. Under the floor, you need to put a board with a width of forty millimeters. When the double strapping will be done, you will also need to put the bar. Thus, all the logs will be stacked on it, and not cut.

At the next stage of the search for an answer to the question of how to build a bath with your own hands from a bar, you should start erecting a log house. It is worth knowing that the thickness of the walls at the same time should reach about 90 millimeters. The optimum height of the bath is 2.35 m. In total there should be about seventeen rims in such a building. The length of the nails that will be used for installation should reach 200 millimeters. Remember: the hats should be drowned in a bar about three centimeters. This is required to ensure that when laying the next crown, the nail does not create any obstacles. At the moment when the height of the frame will be about 90 centimeters from the floor, it will be necessary to begin to cut through the window openings. Usually their height reaches 1.2 meters, and width - one meter. It is also necessary to leave about six centimeters above the cut openings so that there will not be any distortions afterwards.

How to build a bath with your own hands from a bar, when this stage will be completed? After the frame is done, you need to move on to installing the rafters. For this, a simple board is usually used, the thickness of which reaches forty millimeters. Do not forget about laying the necessary insulation materials. Then, on the rafters, it is necessary to nail the crate and lay the roof on it.

After all the roofing work is completed, you should begin to finish the interior. At this stage it is necessary to lay first the rough floor, which will later be covered with parchment and a heater. After that it is necessary to make the laying of the finishing floor from the pile board. The ceiling must be nailed directly to the rafters. You need to do this through the glassine.

The question of how to build a bath itself is considered. The only thing left to do was to correct small defects and make shelves, benches, stoves and other mandatory elements inherent in each such construction.